Time differences for Enterococcus faecalis, Staphylococcus aureus, and Escherichia coli survival during microwave irradiation (power 130 W) in the presence of aqueous cobalt and iron ions were investigated. Measured dependencies had “bell” shape forms with maximum bacterial viability between 1 – 2 min becoming insignificant at 3 minutes. The deactivation time for E. faecalis, S. aureus and E.coli in the presence of metal ions were smaller compared to a water control (4–5 min). Although various sensitivities to the metal ions were observed, S. aureus and E. coli and were the most sensitive for cobalt and iron, respectively. The rapid reduction of viable bacteria during microwave treatment in the presence of metal ions could be explained by increased metal ion penetration into bacteria. Additionally, microwave irradiation may have increased the kinetic energy of the metal ions resulting in lower survival rates. The proposed mathematical model for microwave heating took into account the “growth” and “death” factors of the bacteria, forming second degree polynomial functions. Good relationships were found between the proposed mathematical models and the experimental data for bacterial deactivation (coefficient of correlation 0.91 – 0.99).

Microwave water disinfection is a rapid purification technique which can give billions of people access to clean drinking water. However, better understanding of bacterial recovery after microwave heating over time is necessary to determine parameters such as delayed bacterial growth rates and maximum bacterial yields. Mathematical models for Enterococcus faecalis recovery after microwave treatment in optimum growth conditions were developed for times up to 5 minutes using an optical absorbance method. Microwave times below 3 minutes (2,450 MHz, 130 W) showed that bacterial recovery maintained a time-dependent sigmoidal form which included a maximum value. At microwave times greater than three minutes, bacterial recovery, with a time-dependent exponential form, significantly decreased and did not reach the maximum value within the interval of observance (0-8 hours). No bacterial growth was found after 6 minutes of microwave treatment. The prepared mathematical models were produced by transforming the given variables to the logistic or exponential functions. We found that time-dependent maximum growth rates and lag times could be approximated with second order polynomial functions. The determined models can be used as a template to illustrate bacterial survival during water purification using microwave irradiation, in both commercial and industrial processes.

No abstract

Time dependencies of component temperatures for mixtures of immiscible liquids during microwave heating were studied for acetonitrile-cyclohexane and water-toluene. For the first time, we report microwave induced liquid-liquid phase inversion for acetonitrile-cyclohexane mixture: acetonitrile layer was initially at the bottom of the mixture, after 10 sec of microwave heating its density decreased and it inverted to the top of the mixture for the remainder of the microwave heating. This phase inversion could not be achieved by conventional radiant heating. The maximum rate of temperature growth for the polar component of the mixtures was 2 - 5 times larger than for the non-polar component. This suggests that microwave energy is absorbed by polar liquids (water or acetonitrile) and heat is transferred into the non-polar liquid (toluene or cyclohexane) in the mixture by conduction (in case of cyclohexane) or conduction and convection (in case of toluene). Comparison between experimental data and semi-empirical mathematical models, proposed in [Kennedy et at., 2009] showed good correlation. Average relative error between theoretical and experimental results did not exceed 7%. These results can be used to model the temperature kinetics of components for other multiphase mixtures.