Microcombs provide a path to broad-bandwidth integrated frequency combs with low power consumption, which are compatible with wafer-scale fabrication. Yet, electrically-driven, photonic chip-based microcombs are inhibited by the required high threshold power and the frequency agility of the laser for soliton initiation. Here we demonstrate an electrically-driven soliton microcomb by coupling a III–V-material-based (indium phosphide) multiple-longitudinal-mode laser diode chip to a high-Q silicon nitride microresonator fabricated using the photonic Damascene process. The laser diode is self-injection locked to the microresonator, which is accompanied by the narrowing of the laser linewidth, and the simultaneous formation of dissipative Kerr solitons. By tuning the laser diode current, we observe transitions from modulation instability, breather solitons, to single-soliton states. The system operating at an electronically-detectable sub-100-GHz mode spacing requires less than 1 Watt of electrical power, can fit in a volume of ca. 1 cm3, and does not require on-chip filters and heaters, thus simplifying the integrated microcomb.

No abstract

We generalize the coupled mode formalism to study the generation of frequency combs in microresonators with simultaneous Raman and Kerr nonlinearities and investigate an impact of the former on the formation of frequency combs and dynamics of platicons in the regime of the normal group velocity dispersion. We demonstrate that the Raman effect initiates generation of sidebands, which cascade further in four-wave mixing and reshape into the Raman-Kerr frequency combs. We reveal that the Raman scattering induces a strong instability of the platicon pulses associated with the Kerr effect and normal dispersion. This instability results in branching of platicons and complex spatiotemporal dynamics.

Dynamics of platicons caused by the third-order dispersion is studied. It is shown that under the influence of the third-order dispersion platicons obtain angular velocity depending both on dispersion and on detuning value. A method of tuning of platicon associated optical frequency comb repetition rate is proposed.