First-order all-pass filter circuits, both non-inverting and inverting, could be the focus of this article, which could include the design and implementation of first-order all-pass filter circuits. Using a standard integrated circuit (IC): AD830, as well as a single resistor and a single capacitor, the proposed first-order all-pass filters could well be built. The AD830 is an integrated circuit (IC) manufactured by Analog Devices Corporation that is available for purchase. The pole frequency and phase response of the proposed all-pass filters could well be directly modified by attuning the resistor in the circuit. Aside from that, the output voltage has a low impedance, making it appropriate for use in voltage-mode circuits. In addition, the proposed first-order all-pass filter is used to design the multiphase sinusoidal oscillator, which serves as an example of an application wherein the oscillation condition can be adjusted without impacting the frequency. The gain and phase responses of the proposed all-pass filters, as well as their phase response adjustment, time-domain response, and total harmonic distortion of signals, are all shown via computer simulation using the PSPICE software, as well as their experimental results. For the proposed circuits, a statistical analysis is coupled with a Monte Carlo simulation to estimate the performance of the circuits. In accordance with the results of this study, a theoretical design suitable for developing a worksheet for teaching and learning in electrical and electronic engineering laboratories has already been developed

No abstract

This study describes a simple design for a single active element sinusoidal oscillator with a quadrature signal. A current conveyor transconductance amplifier (CCTA), a single resistor, and two grounded capacitors are used in the first circuit. The second circuit is improved by using a current-controlled current conveyor transconductance amplifier (CCCCTA) and two grounded capacitors without a passive resistor, which means the grounded capacitor is suitably implemented for the IC fabrication. The oscillation condition and frequency of both circuits can be controlled using the same method that concurrently adjusts the DC bias current and the resistance as well as the oscillation frequency can be independently adjusted by capacitances. The CCTA is achieved by cascading the integrated circuits (IC) AD844 and LM13700, made by Analog Devices Corporation and Texas Instruments, respectively, which are available for commercial purchase. The sinusoidal quadrature signals in the time-domain and frequency-domain can be shown with computer simulations and the results of experiments. The Monte Carlo Analysis is also utilized to examine the oscillation frequency with the influence of passive element tolerance errors. The predicted oscillation frequency has a standard variation of about 20.04 kHz, with a maximum frequency of approximately 346.89 kHz and a minimum frequency of approximately 259.09 kHz. In addition, the mean and median frequencies are 296.10 and 293.98 kHz, respectively. The results of this study indicate that computer simulation and experiment are similar to a theoretical analysis, making them suiTable for use in the teaching of electrical and electronic engineering