No abstract

No abstract

The objectives of this study were to evaluate some of physical and mechanical properties of rubberwood (Hevea brasiliensis) as function of microwave heat treatment process. The specimens were heat treated at three temperature levels of 150 °C, 180 °C, and 220 °C for 20 min in a small microwave oven connected to a computer. Bending characteristics, namely modulus of elasticity (MOE), modulus of rupture (MOR) as well as hardness of the samples were tested. Dimensional stability in the form of swelling and water absorption of the specimens were also determined. Based on the findings in this work it appears that microwave can be used successfully for heat treatment of rubberwood. Overall mechanical properties of the samples were adversely influenced by the treatment. MOE, MOR and hardness values of the samples treated at a temperature of 220 °C had 2.37, 3.69, and 2.12 times reduced than those of control samples, respectively. Dimensional stability of the heat treated samples as a result of 2-h and 24-h water soaking improved. Micrographs take from scanning electron microscope (SEM) and transmission electron microscope (TEM) revealed that certain amount of damage took place in the cellwall of the treated specimens. Overall discoloration on the samples due to microwave heat treatment was found insignificant.

The objective of this work was to evaluate some of the properties of experimental wood plastic composite (WPC) panels manufactured from a low percentage of rubberwood (Hevea brasiliensis Muell. Arg), waste polyethylene terephthalate (PET) and silica at three different ratios. It was determined that water absorption values of the samples decreased with the increasing amount of PET in the panels. The lowest absorption value of 0.34% was determined for the samples having 40% PET in their content as a result of 24-h soaking. The highest hardness value of 4492 N was found for the samples made with the combination of rubberwood, PET and silica at 10%, 40% and 50%, respectively. The compressive strength of WPC specimens also followed a similar trend with the hardness characteristics of the panel and improved with increasing PET percentage. Statistical analyses revealed that values of compression strength, hardness, 2-h and 24-h water absorption of the specimens made with 20, 30, and 40% PET content resulted in significant difference from each other (p ≤ 0.0001). Based on the findings in this study it appears that increasing silica content in the samples adversely influenced their mechanical properties while creating a certain level of enhancement of water absorption of the specimens. It seems that using a combination of waste PET and a limited amount of silica with a low percentage of wood particles could have the potential to produce value-added environmentally friendly composites to be used for different applications.

The objective of this study was to investigate the basic properties of composite materials that were made from epoxidized natural rubber and nanosilica to be used as blades for drones. Nanocomposite samples were prepared with 5% of epoxidized natural rubber and epoxy resin loaded with 3% nanosilica. Their resistance against accelerated weathering conditions as well as mechanical properties, including flexural strength, impact strength, and hardness, were evaluated. Based on the findings of this work, the impact strength of the samples decreased 13.33% and 33.33% as a result of exposing them to weathering by UV radiation for 168 h and 336 h, respectively. However, their tensile strength properties enhanced 35.71% and 19.05% for the above corresponding exposure time spars. Experimental composite samples that were made in this study would have great potential to be used as raw material for propeller blade for drones based on their properties evaluated within the scope of this work.