In this paper, an implementation of a DC/DC buck converter for electric vehicles charging station and a DSP based closed-loop digital controller design are presented and analyzed. The aim of this work is to achieve an improved control strategy for a Li-ion battery charger implemented on a Real-time test platform. The test platform consists of a popular power pole board (MPCA75136) dedicated to studying the DC/DC converters, and a DSP development kit (TMS320F28379D) that is used to drive the DC/DC buck converter. The control strategy is based on a digital control system containing the closed-loop current controller followed by a pulse width modulation block, and on a real time state of charge estimation technique for a Li-ion battery. However, the overall control design is modeled on Simulink via block diagrams, and automatically generated code that is targeted into the DSP processor. Simulation and experimental results have shown the effectiveness of the proposed test bench and its external digital control strategy via a charging scenario for electric vehicles batteries.

No abstract

This paper presents a test of a new three-phase multilevel inverter for PV system applications with reduced number of used DC sources and power switches. The topology of the inverter is designed using an electric assemblage of a two-level dc-dc boost converter (TLBC) with a simplified three-phase multilevel DC-AC converter (THPMC). The TLBC generates two balanced output DC voltages, while the THPMC converts these two DC voltages and generates three-phase AC voltages with five levels per line. Two modulation control techniques are used and tested with the proposed PV system on PSIM and on ISIS Proteus software. The achieved results prove the simplicity and efficiency of the proposed three-phase inverter.

This paper introduces the implementation of a single-phase multilevel inverter for a grid-connected photovoltaic system. The considered topology contains a full bridge converter tied to an auxiliary circuit made of two power switches. A proportional integral (PI) current controller is established with this inverter to inject a sinusoidal current into the grid with a power factor near to unity. The studied system is tested on Matlab/Simulink and verified by experiment through a test bench comprising of a fabricated prototype and a DSP TMS320F28379D. The obtained results prove the efficiency of the inverter to maintain a direct power flow from DC sources, such as solar panels, to the grid by respecting some normalized criteria for this operation.

The main objective of this paper is to present a test a single phase switched capacitor nine-level inverter for PV system applications, with a simple harmonic elimination method. The main elements of the used multilevel inverter are a high power switched capacitor DC-DC converter and a high power DC-AC converter. The studied system with the proposed control method was tested on MATLAB/SIMULINK with solar panels. Also, an experimental test bench was prepared and used to validate the simulation results. The all obtained results prove the high efficiency of the studied PV system with the implemented control method.