This paper presents a novel design structure of a series fed array antenna for desired shaped beam pattern synthesis. The desired beam shape is obtained by varying the width of patch elements. A uniform array is designed for the desired frequency, and then the proportionate values of the widths are calculated using amplitude coefficients obtained from the Woodward Lawson array synthesis method, while keeping excitation phase and inter element spacing constant. The proposed antenna is designed and simulated in HFSS. A prototype is fabricated on FR-4 epoxy dielectric material and tested at 12.5 GHz. The overall antenna has a compact size of 112 mm×34 mm×0.8 mm. The array structure exhibits impedance bandwidth of 1.8 GHz and fractional bandwidth of 15.2%, from 11 GHz to 12.8 GHz frequency range with return loss of −29.6 dB and high gain of 14.7 dB. The series fed configuration results in a VSWR of 1.38 and considerably low side lobe level of −21 dB. There is a fine similarity between simulation and fabrication measurement parameter values such as return loss, VSWR, gain, and bandwidth.

In this work, a substrate integrated waveguide slot array filtering antenna for dual band applications is presented. This novel design performs the functions of both a filter and an antenna simultaneously. The main intention of this work is to design a circuit that separates the frequencies in a dual band operation. The antenna is designed as an integration of two parts; the upper part operates at 10.2 GHz while the lower part operates at 16.4 GHz. In each part, an array of five longitudinal slots is incorporated, as well as a SIW antenna with complementary split ring resonators that operate as a band pass filter at the front end. Each slot array antenna is designed for a specific frequency band, and its function depends upon its preceding band pass filter. The two band pass filters allow only signals from the frequency bands for which they are designed to their corresponding slot array antennas. This technique, along with properly spaced metal vias of the SIW antenna, prevents any leakage and hence reduces interference in dual band operation. Both the band pass filter and the antenna can be built on the same planar board. The antenna is fed through a microstrip to SIW taper transition. CST Microwave Studio software is used for optimization and simulation of the structure. The antenna was built on an RT Duroid 5880 and tested to investigate practical validation. The antenna has a bandwidth of 1.9 GHz, from 9.2 GHz to 11.1 GHz in the X-band, and 2.2 GHz, from 15.6 GHz to 16.9 GHz in the Ku band. The gain pattern is unidirectional in nature and has low side lobe levels of −24 dB and −21 dB at resonant frequencies. A noticeable difference that is greater than 20 dB between co-polarization and cross-polarization is observed. The dimensions of the antenna are 56 mm × 32 mm × 0.508 mm. There is an excellent similarity between the simulated and measured results.