The dissociative chemisorption of small molecules such as methane and water on metal surfaces is a key step in many important catalyzed reactions. However, it has only very recently become possible to directly compare theory with molecular beam studies of these reactions. For most experimental conditions, such a comparison requires accurate methods for introducing the effects of lattice motion into quantum reactive scattering calculations. We examine these methods and their recent application to methane and water dissociative chemisorption. New results are presented for CO chemisorption and methane dissociation at step edges. The type of molecule-lattice coupling that leads to a strong variation in the dissociative sticking of methane with temperature is shown to occur for many polyatomic-metal systems. Improvements to these models are discussed. The ability to accurately compare theory with molecular beam experiments should lead to improved density functionals and consequently more accurate thermal rate constants for these important reactions.

A fully quantum approach based on an expansion in vibrationally adiabatic eigenstates is used to explore the dissociative chemisorption of H2O, HOD, and D2O on Ni(111). For this late barrier system, excitation of both the bending and stretching modes significantly enhances dissociative sticking. The vibrational efficacies vary somewhat from mode-to-mode but are all relatively close to one, in contrast to methane dissociation, where the behavior is less statistical. Similar to methane dissociation, the motion of lattice atoms near the dissociating molecule can significantly modify the height of the barrier to dissociation, leading to a strong variation in dissociative sticking with substrate temperature. Given a rescaling of the barrier height, our results are in reasonable agreement with measurements of the dissociative sticking of D2O on Ni(111), for both laser-excited molecules with one or two quanta of excitation in the antisymmetric stretch and in the absence of laser excitation. Even without laser excitation, the beam contains vibrationally excited molecules populated at the experimental source temperature, and these make significant contributions to the sticking probability. At high collision energies, above the adiabatic barrier heights, our results correlate with these barrier heights and mode softening effects. At lower energies, dissociative sticking occurs primarily via vibrationally nonadiabatic pathways. We find a preference for O-H over O-D bond cleavage for ground state HOD molecules at all but the highest collision energies, and excitation of the O-H stretch gives close to 100% O-H selectivity at lower energies. Excitation of the O-D stretch gives a lower O-D cleavage selectivity, as the interaction with the surface leads to energy transfer from the O-D stretch into the O-H bond, when mode softening makes these vibrations nearly degenerate.

A quantum approach based on an expansion in vibrationally adiabatic eigenstates is used to explore the dissociative chemisorption of CO on Ni(100). The largest barrier to reaction corresponds to the formation of a bent anionic molecular precursor, bound to the surface by about 0.24 eV. The barrier to dissociation from this state is small. Our computed dissociative sticking probabilities on Ni(100) for molecules in the ground state are in very good agreement with available experimental data, reasonably reproducing the variation in reactivity with collision energy. Vibrational excitation of the incident CO can enhance reactivity, particularly for incident energies at or below threshold, and there is clear mode specific behavior. Both the vibrational enhancement and the increase in dissociative sticking with surface temperature are much weaker than that found in recent studies of methane and water dissociative chemisorption. The energetics for CO adsorption and dissociation on the stepped Ni(711) surface are found to be similar to that on Ni(100), except that the barrier to dissociation from the anionic precursor is even smaller on Ni(711). We predict that the dissociative sticking behavior is similar on the two surfaces.

No abstract

In this work, for the first time, an analytical four-dimensional representation for the intermolecular potential of the N(2)-CO dimer is constructed from ab initio calculations. The most stable structure of dimer is found to be a distorted T-shape conformation with CO forming the top and N(2) the leg of T. Important structures of the dimer are characterized, and surprisingly, it is found that in contrast with general assumptions, the potential energy surface of the N(2)-CO dimer has a single symmetry unique minimum. The energy profile of a minimum energy path that connects two T-shaped saddle points to the minimum structure is derived. Important structures are characterized along this path to represent the concerted internal rotation of monomers within the complex. The second virial coefficient is calculated from the fitted PES, and reasonable agreement is found with recent experimental results.