A new class of 'powder-in-tube' Mg-B superconducting conductors has been prepared using two different methods: an in situ technique where an Mg + 2B mixture was used as a central conductor core and reacted in situ to form MgB 2 , and an ex situ technique where fully reacted MgB 2 powder was used to fill the metal tube. Conductors were prepared using silver, copper and bimetallic silver/stainless steel tubes. Wires manufactured by the in situ technique, diffusing Mg to B particles experienced ∼25.5% decrease in density from the initial value after cold deformation, due to the phase transformation from Mg + 2(β − B) → MgB 2 all with hexagonal structure.A comparative study of the intergranular current and grain connectivity in wires was conducted by AC susceptibility measurements and direct four point transport measurements. Using a SQUID magnetometer, magnetization versus magnetic field (M-H ) curves of the round wires before and after sintering and reactive diffusion were measured at 5 K and in magnetic fields up to 5 T to define the J cmag . The direct current measurements were performed in self field at 4.2 K. A comparison between zero-field-cooled (ZFC) and field-cooled (FC) susceptibility measurements for sintered Ag/MgB 2 , and reacted Cu/Mg + 2B conductors revealed systematic differences in the flux pinning in the wires which is in very good agreement with direct high transport current measurements.

The key technical challenges that fuel cell developers need to address are performance, durability, and cost. All three need to be achieved in parallel; however, there are often competitive tensions, e.g., performance is achieved at the expense of durability. Stability and resistance to degradation under prolonged operation are key parameters. There is considerable interest in developing new cathodes that are better able to function at lower temperature to facilitate low cost manufacture. For anodes, the ability of the solid oxide fuel cell (SOFC) to better utilize commonly available fuels at high efficiency, avoid coking and sulfur poisoning or resistance to oxidation at high utilization are all key. Optimizing a new electrode material requires considerable process development. The use of solution techniques to impregnate an already optimized electrode skeleton, offers a fast and efficient way to evaluate new electrode materials. It can also offer low cost routes to manufacture novel structures and to fine tune already known structures. Here impregnation methodologies are discussed, spectral and surface characterization are considered, and the recent efforts to optimize both cathode and anode functionalities are reviewed. Finally recent exemplifications are reviewed and future challenges and opportunities for the impregnation approach in SOFCs are explored.

No abstract

This paper reports the successful application of ink-jet printing to the deposition of both continuous coatings and multi-filamentary structures of YBCO. Stable inks have been prepared using both the established TFA-MOD route and novel fluorine-free precursors with appropriate rheological properties for ink-jet printing. Continuous and well textured coatings with lengths exceeding 100 m and a thickness of 0.5 µm have been deposited by electromagnetic ink-jet printing from TFA precursors on LZO-buffered Ni–W substrates and samples have achieved a Jc around 1.5 MA cm−2 (self-field, 77 K). On single crystal substrates, continuous coatings and multi-filamentary structures have been deposited using piezoelectric ink-jet printing both from TFA- and water-based precursors, achieving Jc values up to 3 MA cm−2.