The aim of this paper is to calculate an accurate large-scale flatfield for the STEREO HI-1 instruments. This is done by analysing the variation in intensity of stars in the background starfield as they pass across the CCD. In order to use the background starfield, a photometric calibration is performed which defines a HI magnitude scale and a conversion between this scale and measured intensity. The photometric calibration uses stellar spectra folded through the instrument response to make initial intensity predictions. However, a secondary prediction method based on the photometric calibration, which blends the R-, V-and B-magnitudes of a star, is derived for stars with no spectral information.To perform this calibration, an initial analysis of the shape of the point spread function was required. This indicated that the PSF for the HI-1s is well approximated by a Gaussian function and does not vary substantially from the centre of the field-of-view to the corners and is essentially constant over time.In addition, a solar spectrum folded through the instrument response is used to determine conversion factors to convert from HI intensity units into mean solar brightness, S10 and SI units, for diffuse or extended sources.

Abstract. During a 4-week run in October-November 2006, a pilot experiment was performed at the CERN Proton Synchrotron in preparation for the Cosmics Leaving OUtdoor Droplets (CLOUD) experiment, whose aim is to study the possible influence of cosmic rays on clouds. The purpose of the pilot experiment was firstly to carry out exploratory measurements of the effect of ionising particle radiation on aerosol formation from trace H 2 SO 4 vapour and secondly to provide technical input for the CLOUD design. A total of 44 nucleation bursts were produced and recorded, with formation rates of particles above the 3 nm detection threshold of between 0.1 and 100 cm −3 s −1 , and growth rates between 2 and 37 nm h −1 . The corresponding H 2 SO 4 conCorrespondence to: J. Duplissy (jonathan.duplissy@cern.ch) centrations were typically around 10 6 cm −3 or less. The experimentally-measured formation rates and H 2 SO 4 concentrations are comparable to those found in the atmosphere, supporting the idea that sulphuric acid is involved in the nucleation of atmospheric aerosols. However, sulphuric acid alone is not able to explain the observed rapid growth rates, which suggests the presence of additional trace vapours in the aerosol chamber, whose identity is unknown. By analysing the charged fraction, a few of the aerosol bursts appear to have a contribution from ion-induced nucleation and ion-ion recombination to form neutral clusters. Some indications were also found for the accelerator beam timing and intensity to influence the aerosol particle formation rate at the highest experimental SO 2 concentrations of 6 ppb, although none was found at lower concentrations. Overall, the exploratory measurements provide suggestive evidence for ion-induced nucleation or ion-ion recombination as sources of aerosol Published by Copernicus Publications on behalf of the European Geosciences Union. particles. However in order to quantify the conditions under which ion processes become significant, improvements are needed in controlling the experimental variables and in the reproducibility of the experiments. Finally, concerning technical aspects, the most important lessons for the CLOUD design include the stringent requirement of internal cleanliness of the aerosol chamber, as well as maintenance of extremely stable temperatures (variations below 0.1 • C).

No abstract

In this paper we present in-situ satellite data, theory and laboratory validation that show how small scale collisionless shocks and mini-magnetospheres can form on the electron inertial scale length. The resulting retardation and deflection of the solar wind ions could be responsible for the unusual "lunar swirl" patterns seen on the surface of the Moon.Miniature magnetospheres have been found to exist above the lunar surface [1] and are closely related to features known as "lunar swirls" [2]. Mini-magnetospheres exhibit features that are characteristic of normal planetary magnetospheres namely a collisionless shock. Here we show that it is the electric field associated with the small scale collisionless shock that is responsible for deflecting the incoming solar wind around the minimagnetosphere. These ions impacting the lunar surface resulting in changes to the appearance of the albedo of the lunar "soil" [2]. The form of these swirl patterns therefore, must be dictated by the shapes of the collisionless shock.Collisionless shocks are a classic phenomena in plasma physics, ubiquitous in many space and astrophysical scenarios [3]. Well known examples of collisionless shocks exist in the heliosphere, where the shock is formed by the solar wind interacting with a magnetised planet. What is a surprise is the size of the mini-magnetospheres, of the order of several 100 km; orders of magnitude smaller than the planetary versions. Results from various lunar survey missions have built up a good picture of these collisionless shocks.These collisionless shocks have a characteristic structure in which the ions are reflected from a rather narrow layer, of the order of the electron skin depth c/ω pe (where c is the speed of light and ω pe is the electron plasma frequency), by an electrostatic field that is a consequence of the magnetised electrons and unmagnetised ions. The narrow discontinuity in the shock structure produces a specular reflected ion component with a velocity equal to or greater than the incoming solar wind velocity. The reflected ions from a counter-propagating component to the solar wind flow that form the magnetic foot region, which extends about an ion Larmor orbit upstream from the shock. This occurs when the Mach number (the ratio of flow velocity to Alfvén velocity) is of the order 3 or less.We have carried out laboratory experiments using a plasma wind tunnel, to investigate mini-magnetospheres

No abstract