A comprehensive study has been performed to determine the influence of vane-blade spacing on transonic turbine stage aerodynamics. In Part I of this paper, an investigation of the effect of turbine vane–blade interaction on the time-mean airfoil surface pressures and overall stage performance parameters is presented. Experimental data for an instrumented turbine stage are compared to two- and three-dimensional results from four different time-accurate Navier–Stokes solvers. Unsteady pressure data were taken for three vane-blade row spacings in a short-duration shock tunnel using surface-mounted, high-response pressure sensors located along the midspan of the airfoils. Results indicate that while the magnitude of the surface pressure unsteadiness on the vane and blade changes significantly with spacing, the time-mean pressures and performance numbers are not greatly affected.

This paper presents results of a combined experimental/computational investigation into the effects of vane–blade spacing on the unsteady aerodynamics of a transonic turbine stage. Time-resolved data were taken in a shock-tunnel facility in which the flow was generated with a short-duration source of heated and pressurized air. This data is compared with the results obtained from four unsteady Navier–Stokes solvers. The time-resolved flow for three axial spacings is examined. For each vane–blade spacing, the inlet conditions were nearly identical and the vane exit flow was transonic. Surface-mounted high-response pressure transducers at midspan were used to obtain the pressure measurements. The computed two-dimensional unsteady airfoil surface pressure predictions are compared with the Kulite pressure transducer measurements. The unsteady and axial spacing effects on loading and performance are examined. In general the numerical solutions compared very favorably with each other and with the experimental data. The overall predicted stage losses and efficiencies did not vary much with vane/blade axial spacing. The computations indicated that any increases in the blade relative total pressure loss were offset by a decrease in vane loss as the axial spacing was decreased. The decrease in predicted vane total pressure loss with decreased axial spacing was primarily due to a reduction in the wake mixing losses. The increase in predicted blade relative total pressure loss with a decrease in axial spacing was found to be mainly due to increased vane wake/blade interaction.

This paper presents results of a combined experimental/computational investigation into the effects of vane-blade spacing on the unsteady aerodynamics of a transonic turbine stage. Time-resolved data were taken in a shock-tunnel facility in which the flow was generated with a short-duration source of heated and pressurized air. This data is compared with the results obtained from four unsteady Navier-Stokes solvers. The time-resolved flow for three axial spacings is examined. For each vane-blade spacing, the inlet conditions were nearly identical and the vane exit flow was transonic. Surface-mounted high-response pressure transducers at midspan were used to obtain the pressure measurements. The computed two-dimensional unsteady airfoil surface pressure predictions are compared with the Kulite pressure transducer measurements. The unsteady and axial spacing effects on loading and performance are examined. In general the numerical solutions compared very favorably with each other and with the experimental data. The overall predicted stage losses and efficiencies did not vary much with vane/blade axial spacing. The computations indicated that any increases in the blade relative total pressure loss were offset by a decrease in vane loss as the axial spacing was decreased. The decrease in predicted vane total pressure loss with decreased axial spacing was primarily due to a reduction in the wake mixing losses. The increase in predicted blade relative total pressure loss with a decrease in axial spacing was found to be mainly due to increased vane wake/blade interaction.

A comprehensive study has been performed to determine the influence of vane-blade spacing on transonic turbine stage aerodynamics. In Part I of this paper, an investigation of the effect of turbine vane-blade interaction on the time-mean airfoil surface pressures and overall stage performance parameters is presented. Experimental data for an instrumented turbine stage are compared to two- and three-dimensional results from four different time-accurate Navier-Stokes solvers. Unsteady pressure data were taken for three vane-blade row spacings in a short-duration shock tunnel using surface-mounted, high-response pressure sensors located along the midspan of the airfoils. Results indicate that while the magnitude of the surface pressure unsteadiness on the vane and blade changes significantly with spacing, the time-mean pressures and performance numbers are not greatly affected.

A code using the MacCormack scheme modified t o be TVD has been written t o analyze the flow in a magnetohydrodynamic conductivity channel driven by a reflected shock tube with a heated driver. Items considered include the thermodynamic and electrical properties of the potassium-seeded plasma, both with and without a current applied along the flow, and the steady-state test time in the channel. An inviscid, quasi-one-dimensional model was used with an electric power flux term included in the energy equation to account for the energy addition of the applied current. I t was determined that, as a consequence of the high temperature ratios across the primary diaphragm in the shock tube, no steady-state window exists in the channel. Conductivity channel investigations revealed that Joule heating effects begin at a channel current of two Amperes and become significant above a current of ten Amperes.