There is a renewed interest in dynamic characteristics of damaged aircraft both in order to assess survivability and to develop control laws to enhance survivability. This paper presents a set of flight dynamics equations of motion for a rigid body not necessarily referenced to the body's center of mass. Such equations can be used when the body loses a portion of its mass and it is desired to track the motion of the body's previous center of mass/reference frame now that the mass center has moved to a new position. Furthermore, results for equations presented in this paper and equations in standard aircraft simulations are compared for a scenario involving a generic transport aircraft configuration subject to wing damage.

This paper presents an approach to on-line control design for aircraft that have suffered either actuator failure, missing effector surfaces, surface damage, or any combination.The approach is based on a modified version of nonlinear dynamic inversion.

Control of complex Vertical Take-Off and Landing (VTOL) aircraft traversing from hovering to wing born flight mode and back poses notoriously difficult modeling, simulation, control, and flight-testing challenges. This paper provides an overview of the techniques and advances required to develop the GL-10 tilt-wing, tilt-tail, long endurance, VTOL aircraft control system. The GL-10 prototype's unusual and complex configuration requires application of state-of-the-art techniques and some significant advances in wind tunnel infrastructure automation, efficient Design Of Experiments (DOE) tunnel test techniques, modeling, multi-body equations of motion, multi-body actuator models, simulation, control algorithm design, and flight test avionics, testing, and analysis. The following compendium surveys key disciplines required to develop an effective control system for this challenging vehicle in this on-going effort.

A modified derivation of nonlinear dynamic inversion provides the theoretical underpinnings for a reconfigurable control law for aircraft that have suffered combinations of actuator failures, missing effector surfaces, and aerodynamic changes. The approach makes use of acceleration feedback to extract information pertaining to any aerodynamic change and thus does not require a complete aerodynamic model of the aircraft. The control law does require feedback of effector positions to accommodate actuator dynamics. Both accelerometer and rate gyro failure detection and isolation (FDI) systems are implemented, allowing up to three independent failures for each FDI system as long as they are in different axes. Nonlinear simulation results show that the FDI systems improve the robustness to accelerometer/rate gyro uncertainties. An advanced tailless aircraft model is used to demonstrate the concepts.The simulation includes accelerometer and rate gyro noise and bias, failures due to accelerometers, rate gyros, and actuators, and modeled missing surfaces that cause airplane aerodynamic changes.

This paper describes a general form of nonlinear dynamic inversion control for use in a generic nonlinear simulation to evaluate candidate augmented aircraft dynamics. The implementation is specifically tailored to the task of quickly assessing an aircraft's control power requirements and defining the achievable dynamic set. The achievable set is evaluated while undergoing complex mission maneuvers, and perfect tracking will be accomplished when the desired dynamics are achievable. Variables are extracted directly from the simulation model each iteration, so robustness is not an issue. Included in this paper is a description of the implementation of the forces and moments from simulation variables, the calculation of control effectiveness coefficients, methods for implementing different types of aerodynamic and thrust vectoring controls, adjustments for control effector failures, and the allocation approach used. A few examples illustrate the perfect tracking results obtained.