Ceramic tile production is an industrial process where energy efficiency management is crucial, given the high amount of energy (electrical and thermal) required by the production cycle. This study presents the preliminary results of a research project aimed at defining the benefits of using combined heat and power (CHP) systems in the ceramic sector. Data collected from ten CHP installations allowed us to outline the average characteristics of prime movers, and to quantify the contribution of CHP thermal energy supporting the dryer process. The electric size of the installed CHP units resulted in being between 3.4 MW and 4.9 MW, with an average value of 4 MW. Data revealed that when the goal is to maximize the generation of electricity for self-consumption, internal combustion engines are the preferred choice due to higher conversion efficiency. In contrast, gas turbines allowed us to minimize the consumption of natural gas input to the spray dryer. Indeed, the fraction of the dryer thermal demand (between 600–950 kcal/kgH2O), covered by CHP discharged heat, is strictly dependent on the type of prime mover installed: lower values, in the range of 30–45%, are characteristic of combustion engines, whereas the use of gas turbines can contribute up to 77% of the process’s total consumption.

Ceramic tile manufacturing is a highly energy-intensive process. Concerns about carbon emissions and energy costs make energy management crucial for this sector, which holds a leading role in Italian industry. The paper discusses the energetic and environmental performance of cogeneration (CHP) in the ceramic industry, where prime mover exhaust heat is supplied to a spray-dryer system, contributing to the satisfaction of the thermal demand and decreasing natural gas consumption. A thermodynamic model of a dryer unit, validated against real data, has been set-up to provide a detailed representation of the thermal fluxes involved in the process. Then, the thermal integration with two types of CHP prime movers of similar electric size (4 MW) is investigated. Energetic results show that the gas turbine can contribute up to 81% of dryer thermal consumption, whilst internal combustion engine contribution is limited to 26%. A methodology was ad-hoc defined for the environmental assessment of CHP, accounting for global (CO2) and local (CO and NOX) emissions. Results confirm that CHP units guarantee reduction of CO2 and NOx compared to separate generation, with maximum values equal to 81 g/kWhth and 173 mg/kWhth, respectively; CO emission is decreased only in the case of gas turbine operation, with savings equal to 185 mg/kWhth.