The focus of this paper is the designing of ultrafine-grained aluminum/steel laminated metal composites for innovative lightweight materials concepts used for cyclic loading. These ultrafine-grained composites are produced by the accumulative roll bonding process. Three different aluminum/steel composites are studied, where the position of the steel layers is varied, to investigate the influence of the layer architecture. The mechanical properties are measured in monotonic and cyclic three-point bending tests. The influence of the meso-and microstructure are intensively studied by scanning electron microscope observations. Furthermore, the internal stresses during elastic straining are calculated by a finite element simulation. In the composites, both monotonic and cyclic mechanical properties are strongly increased and are clearly higher as expected by a linear rule of mixtures of the constituent materials. This increase is particularly high for the fatigue properties resulting in a strongly enhanced specific fatigue limit of the composites.

No abstract

Additive manufacturing (AM) of Ni-base superalloy components can lead to a significant reduction of weight in aerospace applications. AM of IN718 by selective laser melting results in a very fine dendritic microstructure with a high dislocation density due to the fast solidification process. The complex phase composition of this alloy, with three different types of precipitates and high residual stresses, necessitates adjustment of the conventional heat treatment for AM parts. To find an optimized heat treatment, the microstructures and mechanical properties of differently solution heat-treated samples were investigated by transmission and scanning electron microscopy, including electron backscatter diffraction, and compression tests. After a solution heat treatment (SHT), the Nb-rich Laves phase dissolves and the dislocation density is reduced, which eliminates the dendritic substructure. SHT at 930 or 954°C leads to the precipitation of the δ-phase, which reduces the volume fraction of the strengthening γ′-and γ′′-phases formed during the subsequent two stage aging treatment. With a higher SHT temperature of 1000°C, where no δ-phase is precipitated, higher γ′ and γ′′ volume fractions are achieved, which results in the optimum strength of all of the solution heat treated conditions.

Modular composites with a 3D periodic structure, consisting of a major brittle inorganic phase (building blocks) and a minor viscoelastic organic matrix, offer great potentials for improved fracture toughness and failure probability in polymer‐ceramic composites. Alumina building blocks with dimensions of 1500 μm were assembled by a novel placing system equipped with an automatic optical inspection (AOI) system. The AOI system coupled with shape recognition enables simultaneous dimensional characterization, tolerance sorting, and flexible placing of different shaped building blocks. 3D periodic structures with cubic, monoclinic, and triclinic unit cells were fabricated by high accuracy placing of cubic building blocks enabling near‐net shape manufacturing. The placing precision of the assembled structures was determined by μCT to have a maximum deviation of ±78 μm. The structures were afterward infiltrated with a soft epoxy resin to fabricate epoxy‐alumina composites. The brick‐and‐mortar like building block arrangements of the monoclinic and triclinic structures exhibited improved bending strength, fracture toughness, and failure probability compared to monolithic epoxy, due to crack deflection and pull‐out toughening mechanisms. A maximum bending strength of 35.1 ± 7.5 MPa, a work‐of‐fracture of 814.7 ± 255.1 J/m² and a calculated fracture toughness of 4.8 ± 0.8 MPam for the triclinic structures was achieved.