No abstract

The particle size effect on the formation of OH adlayer, the CO bulk oxidation, and the oxygen reduction reaction (ORR) have been studied on Pt nanoparticles in perchloric acid electrolyte. From measurements of the CO displacement charge at controlled potential, the corresponding surface charge density versus potential curves yielded the potentials of total zero charge (pztc), which shifts approximately 35 mV negative by decreasing the particle size from 30 nm down to 1 nm. As a consequence, the energy of adsorption of OH is more enhanced, that is, at the same potential the surface coverage with OH increases by decreasing the particle size, which in turn affects the catalytic reactions thereon. The impact of the electronically induced potential shift in the OH adsorption is demonstrated at the CO bulk oxidation, in which adsorbed OH is an educt species and promotes the reaction, and the ORR, where it can act as a surface site blocking species and inhibits the reaction.

Using high-resolution transmission electron microscopy (TEM), infrared reflection-absorption spectroscopy (IRAS), and electrochemical (EC) measurements, platinum nanoparticles ranging in size from 1 to 30 nm are characterized and their catalytic activity for CO electrooxidation is evaluated. TEM analysis reveals that Pt crystallites are not perfect cubooctahedrons, and that large particles have "rougher" surfaces than small particles, which have some fairly smooth (111) facets. The importance of "defect" sites for the catalytic properties of nanoparticles is probed in IRAS experiments by monitoring how the vibrational frequencies of atop CO (nu(CO)) as well as the concomitant development of dissolved CO(2) are affected by the number of defects on the Pt nanoparticles. It is found that defects play a significant role in CO "clustering"on nanoparticles, causing CO to decrease/increase in local coverage, which yields to anomalous redshift/blueshift nu(CO) frequency deviations from the normal Stark-tuning behavior. The observed deviations are accompanied by CO(2) production, which increases by increasing the number of defects on the nanoparticles, that is, 1 < or = 2 < 5 << 30 nm. We suggest that the catalytic activity for CO adlayer oxidation is predominantly influenced by the ability of the surface to dissociate water and to form OH(ad) on defect sites rather than by CO energetics. These results are complemented by chronoamperometric and rotating disk electrode (RDE) data. In contrast to CO stripping experiments, we found that in the backsweep of CO bulk oxidation, the activity increases with decreasing particle size, that is, with increasing oxophilicity of the particles.