Although most plastic pollution originates on land, current research largely remains focused on aquatic ecosystems. Studies pioneering terrestrial microplastic research have adapted analytical methods from aquatic research without acknowledging the complex nature of soil. Meanwhile, novel methods have been developed and further refined. However, methodical inconsistencies still challenge a comprehensive understanding of microplastic occurrence and fate in and on soil. This review aims to disentangle the variety of state-of-the-art sample preparation techniques for heterogeneous solid matrices to identify and discuss best-practice methods for soil-focused microplastic analyses. We show that soil sampling, homogenization, and aggregate dispersion are often neglected or incompletely documented. Microplastic preconcentration is typically performed by separating inorganic soil constituents with high-density salt solutions. Not yet standardized but currently most used separation setups involve overflowing beakers to retrieve supernatant plastics, although closed-design separation funnels probably reduce the risk of contamination. Fenton reagent may be particularly useful to digest soil organic matter if suspected to interfere with subsequent microplastic quantification. A promising new approach is extraction of target polymers with organic solvents. However, insufficiently characterized soils still impede an informed decision on optimal sample preparation. Further research and method development thus requires thorough validation and quality control with well-characterized matrices to enable robust routine analyses for terrestrial microplastics.

No abstract

Microplastics are the new emerging pollutants ubiquitously detectable in aquatic and terrestrial ecosystems. Fate and behavior, as well as ecotoxicity, are of increasing environmental concern, particularly in sediments and soils as natural sinks. For a global environmental risk assessment, reliable and easy to apply analytical methods are mandatory to obtain comparable data. This is based on the isolation of microplastics out of the solid sample matrices prior to instrumental detection. Thus, this study provides an easy to apply approach for density separation. The technique emerged from a comparative study using different salt solutions to isolate conventional, and for the first time biodegradable, microplastics from different solid sample matrices, i.e., sand, artificial soil, and compost. Four solutions (water, sodium chloride, sodium hexametaphosphate, and sodium bromide) of different densities were applied followed by oxidizing digestion. Finally, the impact of the procedures on size and surface properties of microplastics was tested. Dependent on the sample matrix, the highest recovery rates of 87.3–100.3% for conventional polymers, and 38.2–78.2% for biodegradable polymers, were determined with sodium bromide. It could be shown that the type of solid sample matrix influences the recovery rates and has to be considered when choosing a sample preparation technique. Graphical abstract