Two end member models of how the high elevations in Tibet formed are (i) continuous thickening and widespread viscous flow of the crust and mantle of the entire plateau and (ii) time-dependent, localized shear between coherent lithospheric blocks. Recent studies of Cenozoic deformation, magmatism, and seismic structure lend support to the latter. Since India collided with Asia approximately 55 million years ago, the rise of the high Tibetan plateau likely occurred in three main steps, by successive growth and uplift of 300- to 500-kilometer-wide crustal thrust-wedges. The crust thickened, while the mantle, decoupled beneath gently dipping shear zones, did not. Sediment infilling, bathtub-like, of dammed intermontane basins formed flat high plains at each step. The existence of magmatic belts younging northward implies that slabs of Asian mantle subducted one after another under ranges north of the Himalayas. Subduction was oblique and accompanied by extrusion along the left lateral strike-slip faults that slice Tibet's east side. These mechanisms, akin to plate tectonics hidden by thickening crust, with slip-partitioning, account for the dominant growth of the Tibet Plateau toward the east and northeast.

International audienceFieldwork complemented by SPOT image analysis throws light on current crustal shortening processes in the ranges of northeastern Tibet (Gansu and Qinghai provinces, China). The ongoing deformation of Late-Pleistocene bajada aprons in the forelands of the ranges involves folding, at various scales, and chiefly north-vergent, seismogenic thrusts. The most active thrusts usually break the ground many kilometres north of the range-fronts, along the northeast limbs of growing, asymmetric ramp-anticlines. Normal faulting at the apex of other growing anticlines, between the range fronts and the thrust breaks, implies slip on blind ramps connecting distinct active décollement levels that deepen southwards. The various patterns of uplift of the bajada surfaces can be used to constrain plausible links between contemporary thrusts downsection. Typically, the foreland thrusts and décollements appear to splay from master thrusts that plunge at least 15–20 km down beneath the high ranges. Plio-Quaternary anticlinal ridges rising to more than 3000 m a.s.l. expose Palaeozoic metamorphic basement in their core. In general, the geology and topography of the ranges and forelands imply that structural reliefs of the order of 5–10 km have accrued at rates of 1–2 mm yr−1 in approximately the last 5 Ma. From hill to range size, the elongated reliefs that result from such Late-Cenozoic, NE–SW shortening appear to follow a simple scaling law, with roughly constant length/width ratio, suggesting that they have grown self-similarly. The greatest mountain ranges, which are over 5.5 km high, tens of kilometres wide and hundreds of kilometres long may thus be interpreted to have formed as NW-trending ramp anticlines, at the scale of the middle–upper crust. The fairly regular, large-scale arrangement of those ranges, with parallel crests separated by piggy-back basins, the coevality of many parallel, south-dipping thrusts, and a change in the scaling ratio (from #5 to 8) for range widths greater than #30 km further suggests that they developed as a result of the northeastward migration of large thrust ramps above a broad décollement dipping SW at a shallow angle in the middle–lower crust. This, in turn, suggests that the 400–500 km-wide crustal wedge that forms the northeastern edge of the Tibet–Qinghai plateau shortens and thickens as a thickskinned accretionary prism decoupled from the stronger upper mantle underneath. Such a thickening process must have been coupled with propagation of the Altyn Tagh fault towards the ENE because most thrust traces merge northwestwards with active branches of this fault, after veering clockwise. This process appears to typify the manner in which the Tibet–Qinghai highlands have expanded their surface area in the Neogene. The present topography and structure imply that, during much of that period,

International audienceWe present geological and morphological observations at different scales to constrain rates of faulting and the distribution of deformation in the seismically active Aegean region. We focus first on the 130 km long Corinth Rift, an asymmetric graben where a flight of terraces of marine origin are uplifted. We show that the edges of the terraces lie in the footwall of the normal fault bounding the Corinth Rift and correspond to sea-level highstands of late Pleistocene age. Using a detailed analysis of aerial and SPOT imagery supported by field observations, we have mapped 10 terrace platforms and strandlines ranging in elevation from 10 to 400 m over distances of 2 to 20 km from the fault. The elevation of the terraces' inner edges was estimated at 172 sites with an error of + 5 m. This data set contains a precise description of the uplift and flexure of 10 different palaeohorizontal lines with respect to the present sea level. To date the deformation, we correlate the Corinth terraces with late Pleistocene oxygen-isotope stages of high sea-level stands and with global sea-level fluctuations. Using a thick elastic plate model consistent with our current understanding of the earthquake cycle and a boundary-element technique we reproduce the geometry of the shorelines to constrain both mechanical parameters and the slip on the fault. We show that the seismogenic layer behaves over the long term as if its elastic modulus were reduced by a factor of about 1000. All the terraces are fitted for fault slip increasing in proportion to terrace age, and the component of regional uplift is found to be less than 0.3 mm yr-'. The best fits give a slip rate of 11 f 3 mm yr-' on the main rift-bounding fault over the last 350 kyr. Other geological and morphologic information allows us to estimate the total age of the main fault (z 1 Ma) and to examine the mechanical evolution of the Corinth Rift. The minimum observed sediment thickness in the Gulf places an extreme check on the results of the modelling and a lower bound on slip rate of 6-7 mm yr-' (40 per cent less than estimated with modelling). Even this slip rate is nearly 10 times higher than for comparable features in most of the Aegean and elsewhere in the world. At a larger scale, the spacing and asymmetry of the rift systems in the Aegean suggest strain localization in the upper mantle, with slow extension starting 15 Myr ago or earlier. The more recent (1 Myr), rapid phase of rifting in Corinth partly reactivated this earlier phase of extension. The younger faulting in Corinth appears to result from its present location in the inhomogeneous stress field (process zone) of the south-westward propagating tip of the southern branch of the North Anatolian Fault. We extend these relations to propose a mechanical model for the Late Cenozoic evolution of the Aegean. As the Arabia/Europe collision progressed in eastern Turkey it caused Anatolia to move to the west and the North Anatolian Fault to propagate into the Aegean, where the early slow extension star...

-This paper presents a synthetic view of the geodynamic evolution of the Zagros orogen within the frame of the Arabia-Eurasia collision. The Zagros orogen and the Iranian plateau preserve a record of the long-standing convergence history between Eurasia and Arabia across the Neo-Tethys, from subduction/obduction processes to present-day collision (from ∼ 150 to 0 Ma). We herein combine the results obtained on several geodynamic issues, namely the location of the oceanic suture zone, the age of oceanic closure and collision, the magmatic and geochemical evolution of the Eurasian upper plate during convergence (as testified by the successive Sanandaj-Sirjan, Kermanshah and Urumieh-Dokhtar magmatic arcs), the P-T-t history of the few Zagros blueschists, the convergence characteristics across the Neo-Tethys (kinematic velocities, tomographic constraints, subduction zones and obduction processes), together with a survey of recent results gathered by others. We provide lithospheric-scale reconstructions of the Zagros orogen from ∼ 150 to 0 Ma across two SW-NE transects. The evolution of the Zagros orogen is also compared to those of the nearby Turkish and Himalayan orogens. In our geotectonic scenario for the Zagros convergence, we outline three main periods/regimes: (1) the Mid to Late Cretaceous (115-85 Ma) corresponds to a distinctive period of perturbation of subduction processes and interplate mechanical coupling marked by blueschist exhumation and upper-plate fragmentation, (2) the Paleocene-Eocene (60-40 Ma) witnesses slab break-off, major shifts in arc magmatism and distributed extension within the upper plate, and (3) from the Oligocene onwards (∼ 30-0 Ma), collision develops with a progressive SW migration of deformation and topographic build-up (Sanandaj-Sirjan Zone: 20-15 Ma, High Zagros: ∼ 12-8 Ma; Simply Folded Belt: 5-0 Ma) and with partial slab tear at depths (∼ 10 Ma to present). Our reconstructions underline the key role played by subduction throughout the whole convergence history. We finally stress that such a long-lasting subduction system with changing boundary conditions also makes the Zagros orogen an ideal natural laboratory for subduction processes.