Monte Carlo simulations of emission tomography have proven useful to assist detector design and optimize acquisition and processing protocols. The more realistic the simulations, the more straightforward the extrapolation of conclusions to clinical situations. In emission tomography, accurate numerical models of tomographs have been described and well validated under specific operating conditions (collimator, radionuclide, acquisition parameters, count rates, etc). When using these models under these operating conditions, the realism of simulations mostly depends on the activity distribution used as an input for the simulations. It has been proposed to derive the input activity distribution directly from reconstructed clinical images, so as to properly model the heterogeneity of the activity distribution between and within organs. However, reconstructed patient images include noise and have limited spatial resolution. In this study, we analyse the properties of the simulated images as a function of the properties of the reconstructed images used to define the input activity distributions in (18)F-FDG PET and (131)I SPECT simulations. The propagation through the simulation/reconstruction process of the noise and spatial resolution in the input activity distribution was studied using simulations. We found that the noise properties of the images reconstructed from the simulated data were almost independent of the noise in the input activity distribution. The spatial resolution in the images reconstructed from the simulations was slightly poorer than that in the input activity distribution. However, using high-noise but high-resolution patient images as an input activity distribution yielded reconstructed images that could not be distinguished from clinical images. These findings were confirmed by simulated highly realistic (131)I SPECT and (18)F-FDG PET images from patient data. In conclusion, we demonstrated that (131)I SPECT and (18)F-FDG PET images indistinguishable from real scans can be simulated using activity maps with spatial resolution higher than that used in routine clinical applications.

No abstract

Total-body positron emission tomography (PET) is a useful diagnostic tool for evaluating malignant disease. However, tumour detection is limited by image artefacts due to the lack of attenuation correction and noise. Attenuation correction may be possible using transmission data acquired after or simultaneously with emission data. Despite the elimination of attenuation artefacts, however, tumour detection is still hampered by noise, which is amplified during image reconstruction by filtered backprojection (FBP). We have investigated, as an alternative to FBP, an accelerated expectation maximization (EM) algorithm for its potential to improve tumour detectability in total-body PET. Signal to noise ratio (SNR), calculated for a tumour with respect to the surrounding background, is used as a figure of merit. A software tumour phantom, with conditions typical of those encountered in a total-body PET study using simultaneous acquisition, is used to optimize and compare various reconstruction approaches. Accelerated EM reconstruction followed by two-dimensional filtering is shown to yield significantly higher SNR than FBP for a range of tumour sizes, concentrations and counting statistics (deltaSNR = 6.3 +/- 3.9, p < 0.001). The methods developed are illustrated by examples derived from physical phantom and patient data.

No abstract

Abstract-A clinical SPECT insert for a commercial MRI scanner has been developed within the INSERT project, allowing simultaneous SPECT/MRI studies of the human brain. Here we present preliminary experimental results. The reconstructed resolution was 6-11 mm and the sensitivity 280-440 s-1 /MBq. The INSERT is the first clinical SPECT prototype for simultaneous SPECT/MRI.