[1] The study uses satellite observations, global assimilated aerosol data sets, Atmospheric Brown Clouds (ABC) observatories, a Monte Carlo aerosol-cloud-radiation model and a regional chemical transport model (STEM-2K) to characterize the spatial extent of brown clouds, regional and megacity ABC hot spots, chemical composition and the direct radiative forcing. It presents the first annual cycle of aerosol observations and forcing from the ABC observatories in the Indo-Asia-Pacific regions. East Asia, IndoGangetic Plains, Indonesian region, southern Africa and the Amazon basin are the regional hot spots defined by the criteria that anthropogenic aerosol optical depths (AODs) should exceed 0.3 and absorbing AOD > 0.03. Over these hot spots, as well as in other polluted oceanic regions, the EC mass exceeds 0.5 mg m À3 , the OC mass exceeds 2 mg m À3 and sulfate mass exceeds 10 mg m À3 from the surface to 3 km. The brown clouds also have strong seasonal dependence. In the tropics the seasonal dependence is driven by pollution accumulating during the dry seasons, December to February in Northern Hemisphere tropics and June to August in Southern Hemisphere tropics. In the extratropics the pollution peaks during the summer. The brown cloud problem is not restricted to the tropical regions. Over the eastern half of US and western Europe the AODs exceeds 0.2 and absorption AODs exceed 0.02. Brown clouds also extend well into the western Pacific Ocean, the Indian Ocean reaching as far south as 60°S and the eastern Atlantic Ocean. The largest total SO 2 emission occurs over China and US, while SO 2 emission per unit surface area is maximum over Germany and England. The largest total EC and OC emissions occur over China, but the largest OC emission per unit surface area occur over India. As a result, the maximum negative annual mean TOA direct forcing is over India and Germany. The surface annual-diurnal mean dimming over the regional hot spots is of the order of À10 W m À2 and À20 W m À2 over megacity hotpots. Citation: Ramanathan, V., et al. (2007), Atmospheric brown clouds: Hemispherical and regional variations in long-range transport, absorption, and radiative forcing,

[1] The sulfur transport and deposition model (STEM) is used to study the aerosol seasonality, distribution, and composition over south Asia from September 2004 to August 2005. Model predictions of sulfate, black carbon, primary organic carbon, other anthropogenic particulate matter, windblown mineral dusts, and sea salt are compared at two sites in south Asia where yearlong experimental observations are available from the Atmospheric Brown Cloud (ABC) project. The model predictions are able to capture both the magnitude and seasonality of aerosols over Hanimaadhoo Observatory, Maldives. However, the model is not able to explain the seasonality at the Kathmandu Observatory; but the model does capture Kathmandu's observed annual mean concentration. The absence of seasonal brick kiln emissions within Kathmandu valley in the current inventory is a probable reason for this problem. This model study reveals high-anthropogenic aerosol loading over the Ganges valley even in the monsoonal months, which needs to be corroborated by experimental observations. Modeling results also show a high dust loading over south Asia with a distinct seasonality. Model results of aerosol monthly composition are also presented at five cities in south Asia. Total and fine-mode monthly aerosol optical depth along with contribution from each aerosol species is presented; the results show that the anthropogenic fraction dominates in the postmonsoon and the early dry season with major contributions from sulfate and absorbing aerosols. Model sensitivity studies of dry deposition velocity and wet scavenging efficiency show that model improvements are needed in the treatment of carbonaceous aerosol dry and wet removal processes. Modeled SO 2 conversion rate constrained with sulfate observations at Hanimaadhoo suggests the need to increase model sulfate production rate during the dry season to account for probable sulfate production via heterogeneous pathways.

Abstract. The Kathmandu Valley in south Asia is considered as one of the global "hot spots" in terms of urban air pollution. It is facing severe air quality problems as a result of rapid urbanization and land use change, socioeconomic transformation, and high population growth. In this paper, we present the first full year (February 2013–January 2014) analysis of simultaneous measurements of two short-lived climate forcers/pollutants (SLCF/P), i.e., ozone (O3) and equivalent black carbon (hereinafter noted as BC) and aerosol number concentration at Paknajol, in the city center of Kathmandu. The diurnal behavior of equivalent BC and aerosol number concentration indicated that local pollution sources represent the major contributions to air pollution in this city. In addition to photochemistry, the planetary boundary layer (PBL) and wind play important roles in determining O3 variability, as suggested by the analysis of seasonal changes of the diurnal cycles and the correlation with meteorological parameters and aerosol properties. Especially during pre-monsoon, high values of O3 were found during the afternoon/evening. This could be related to mixing and entrainment processes between upper residual layers and the PBL. The high O3 concentrations, in particular during pre-monsoon, appeared well related to the impact of major open vegetation fires occurring at the regional scale. On a synoptic-scale perspective, westerly and regional atmospheric circulations appeared to be especially conducive for the occurrence of the high BC and O3 values. The very high values of SLCF/P, detected during the whole measurement period, indicated persisting adverse air quality conditions, dangerous for the health of over 3 million residents of the Kathmandu Valley, and the environment. Consequently, all of this information may be useful for implementing control measures to mitigate the occurrence of acute pollution levels in the Kathmandu Valley and surrounding area.

[1] Fourteen research flights were conducted in the Pacific Dust Experiment (PACDEX) during April and May 2007 to sample pollution and dust outbreaks from east Asia as they traveled across the northern Pacific Ocean into North America and interacted with maritime storms. Significant concentrations of black carbon (BC, consisting of soot and other light-absorbing particles measured with a soot photometer 2 instrument) and dust were observed both in the west and east Pacific Ocean from Asian plumes of dust and pollution. BC particles were observed through much of the troposphere, but the major finding is that the percentage of these particles compared with the total number of accumulation mode particles increased significantly (by a factor of 2-4) with increasing altitude, with peak values occurring between 5 and 10 km. Dust plumes had only a small impact on total cloud condensation nuclei at the sampling supersaturations but did exhibit high concentrations of ice nuclei (IN). IN concentrations in dust plumes exceeded typical tropospheric values by 4-20 times and were similar to previous studies in the Saharan aerosol layer when differences in the number concentrations of dust are accounted for. Enhanced IN concentrations were found in the upper troposphere off the coast of North America, providing a first direct validation of the transport of high-IN-containing dust layers near the tropopause entering the North American continent from distant sources. A source-specific chemical transport model was used to predict dust and other aerosols during PACDEX. The model was able to predict several features of the in situ observations, including the general altitudes where BC was found and a peak in the ratio of BC to sulfate between 5 and 10 km.

No abstract