Objectives Canine eosinophilic bronchopneumopathy (EBP) is a poorly understood disease characterized by chronic inflammation of the lower airways. To date, factors affecting the course of the disease are largely unknown. The objective of this study was to investigate the influence of clinical, laboratory, and environmental factors on therapeutic outcome in dogs with EBP. Material and methods Environmental and housing conditions, course of disease, and response to treatment were evaluated using a standardized questionnaire for owners of 29 dogs diagnosed with EBP from 3 different veterinary referral centers in Germany. Data of diagnostic tests (hematology, radiographs, bronchoalveolar-lavage-fluid-(BALF) cytology) were retrospectively obtained from medical records. The influence of the different factors was assessed using Fisher's-exact-test and Mann-Whitney-U- or Kruskal-Wallis-test. Results The proportion of neutrophilic granulocytes in BALF-cytology was significantly higher in dogs with persistent clinical signs compared to dogs that achieved clinical remission (p=0.029). Duration of clinical signs before treatment was significantly longer in dogs with persistent clinical signs (16±12 months) compared to dogs that achieved clinical remission (6±7 months) (p=0.017). Conclusion Early diagnosis and therapy have a decisive influence on the success of treatment. Clinical relevance Dogs with respiratory signs suspicious for EBP should be evaluated in a timely manner to increase the likelihood of clinical remission with an early start of therapy.

BackgroundThree-dimensional ultrasound (3D-US) is used in planning and treatment during external beam radiotherapy. The accuracy of the technique depends not only on the achievable image quality in clinical routine, but also on technical limitations of achievable precision during calibration. Refraction of ultrasound waves is a known source for geometric distortion, but such an effect was not expected in homogenous calibration phantoms. However, in this paper we demonstrate that the discontinuity of the refraction index at the phantom surface may affect the calibration unless the ultrasound probe is perfectly perpendicular to the phantom.MethodsA calibration phantom was repeatedly scanned with a 3D-US system (Elekta Clarity) by three independent observers. The ultrasound probe was moved horizontally at a fixed angle in the sagittal plane. The resulting wedge shaped volume between probe and phantom was filled with water to couple in the ultrasound waves. Because the speed of sound in water was smaller than the speed of sound in Zerdine, the main component of the phantom, the angle of the ultrasound waves inside the phantom increased. This caused an apparent shift in the calibration features which was recorded as a function of the impeding angle. To confirm the magnitude and temperature dependence, the experiment was repeated by two of the observers with a mixture of ice and water at 0 °C and with thermalized tap water at 21 °C room temperature.ResultsDuring the first series of measurements, a linear dependency of the displacements dx of the calibration features on the angle α of the ultrasound probe was observed. The three observers recorded significantly nonzero (p < 0.0001) and very consistent slopes of dx/dα of 0.12, 0.12, and 0.13 mm/°, respectively..At 0 °C water temperature, the slope increased to 0.18 ± 0.04 mm/°. This matched the prediction of Snell’s law of 0.185 mm/° for a speed of sound of 1,402 m/s at the melting point of ice.At 21 °C, slopes of 0.11 and 0.12 mm/° were recorded in agreement with the first experiment at about room temperature. The difference to the theoretical expectation of 0.07 mm/° was not significant (p = 0.09).ConclusionsThe surface refraction of sound waves my affect the calibration of three-dimensional ultrasound. The temperature dependence of the effect rules out alternative explanations for the observed shifts in calibration. At room temperature and for a structure that is 10 cm below the water-phantom interface, a tilt of the ultrasound probe of 10° may result in a position reading that is off by more than half a millimeter. Such errors are of the order of other relevant errors typically encountered during the calibration of a 3D-US system. Hence, care must be taken not to tilt the ultrasound probe during calibration.

Inhalation chambers (ICs) are regularly used in veterinary medicine for the inhalative treatment of chronic respiratory diseases in dogs and cats. Since therapy is usually required lifelong and daily, devices are frequently in use. The aim of this study was to identify bacterial contamination of ICs used for cats and dogs in relation to the applied cleaning measures. Swabs from ICs of 66 cats and 19 dogs with chronic airway diseases were obtained using a standardized protocol and subsequently cultured. A questionnaire was completed by the pet owners regarding the history of their pet’s illness and applied device cleaning measures. Overall, 64% (54/86) of the ICs were found to be contaminated; the mask was significantly (p < 0.001) more often contaminated than other device parts. Most cultured bacteria were environmental contaminants; however, some harbored pathogenic potential. Cleaning frequency and method did not significantly influence the presence of contamination. Bacterial contamination of ICs, used for cats and dogs, is common but is not significantly influenced by the type or frequency of cleaning. To avoid potential infection by opportunistic bacteria, the instruction of pet owners regarding the maintenance of the ICs is recommended.