The atmospheric instability and the corrosive tendency of hexafluorophosphate [PF6]− and fluorosulfonylimide [FSI]− based lithium salts, respectively, are among the major impediments towards their application as electrolytes in high voltage lithium batteries. Herein a new class of Li salts is introduced and their electrochemical behavior is explored. The successful synthesis and characterization are reported, including the crystal structure, of lithium 1,1,1,3,3,3‐(tetrakis)hexafluoroisopropoxy borate (LiBHfip). The oxidative stability of electrolytes of this salt in an ethylene carbonate:dimethyl carbonate mixture (v/v, 50:50) is found to be 5.0 V versus Li+/Li on various working electrodes, showing substantial improvement over a LiPF6 based electrolyte. Moreover, a high stability of an aluminum substrate is observed at potentials up to 5.8 V versus Li+/Li; in comparison, a LiFSI based electrolyte shows prominent signs of Al corrosion above 4.3 V versus Li+/Li. Cells tested with high voltage layered LiNi0.8Mn0.1Co0.1O2 (NMC811) and spinel LiMn2O4 (LMO) cathodes show stable cycling over 200 cycles with capacity retention of 76% and 90%, respectively. The LMO|Li cell maintains this same low capacity fade rate for 1000 cycles even after the salt has been exposed for 24 h to atmospheric conditions (water content ≈0.57 mass%).

We explore a novel ether aided superconcentrated ionic liquid electrolyte; a combination of ionic liquid, N-propyl-N-methylpyrrolidinium bis(fluorosulfonyl)imide (C3mpyrFSI) and ether solvent, 1,2 dimethoxy ethane (DME) with 3.2 mol/kg LiFSI salt,...

Future rechargeable Li metal batteries (LMBs) require a rational electrolyte design to stabilize the interfaces between the electrolyte and both the lithium metal anode and the high voltage cathode. This...

In this work, we demonstrate a rapid protocol to address one of the major barriers that exists in the fabrication of chip devices, creating the micron-sized structures in the substrate material. This approach makes it possible to design, produce, and fabricate a microfluidic system with channel features >10 microm in poly(dimethylsiloxane)(PDMS) in under 8 hours utilizing instrumentation common to most machine shops. The procedure involves the creation of a master template with negative features, using high precision machining. This master is then employed to create an acrylic mold that is used in the final fabrication step to cast channel structures into the PDMS substrate. The performance of the microfluidic system prepared using this fabrication procedure is evaluated by constructing a miniaturized capillary gel electrophoresis (micro-CGE) system for the analysis of DNA fragments. Agarose is utilized as the sieving medium in the micro-CGE device and is shown to give reproducible (RSD (n= 34) approximately 5.0%) results for about 34 individual separations without replenishing the gel. To demonstrate the functionality of the micro-CGE device, a DNA restriction ladder (spanning 26-700 base pairs) and DNA fragments generated by PCR are separated and detected with laser-induced fluorescence (LIF). The microchip is shown to achieve a separation efficiency of 2.53 x 10(5) plates m(-1).