Although being the standard anode material in lithium-ion batteries (LIBs), graphite so far is considered to fail application in sodium-ion batteries (NIBs) because the Na-C system lacks suitable binary intercalation compounds. Here we show that this limitation can be circumvented by using co-intercalation phenomena in a diglyme-based electrolyte. The resulting compound is a stage-I ternary intercalation compound with an estimated stoichiometry of Na(diglyme)2C20. Highlights of the electrode reaction are its high energy efficiency, the small irreversible loss during the first cycle, and a superior cycle life with capacities close to 100 mAh g(-1) for 1000 cycles and coulomb efficiencies >99.87%. A one-to-one comparison with the analogue lithium-based cell shows that the sodium-based system performs better and also withstands higher currents.

Research on sodium-ion batteries has recently been rediscovered and is currently mainly focused on finding suitable electrode materials that enable cell reactions of high energy densities combined with low cost. Naturally, an assessment of potential electrode materials requires a rational comparison with the analogue reaction in lithium-ion batteries. In this paper, we systematically discuss the broad range of different conversion reactions for sodium-ion batteries based on their basic thermodynamic properties and compare them with their lithium analogues. Capacities, voltages, energy densities and volume expansions are summarized to sketch out the scope for future studies in this research field. We show that for a given conversion electrode material, replacing lithium by sodium leads to a constant shift in cell potential ΔE°(Li-Na) depending on the material class. For chlorides ΔE°(Li-Na) equals nearly zero. The theoretical energy densities of conversion reactions of sodium with fluorides or chlorides as positive electrode materials typically reach values between 700 W h kg(-1) and 1000 W h kg(-1). Next to the thermodynamic assessment, results on several conversion reactions between copper compounds (CuS, CuO, CuCl, CuCl2) and sodium are being discussed. Reactions with CuS and CuO were chosen because these compounds are frequently studied for conversion reactions with lithium. Chlorides are interesting because of ΔE°(Li-Na)≈ 0 V. As a result of chloride solubility in the electrolyte, the conversion process proceeds at defined potentials under rather small kinetic limitations.

The abundance of sodium has recently sparked considerable interest in sodium-ion batteries (NIBs). Their similarity to conventional lithium-ion technology is obvious; however, the cell chemistry often significantly deviates. Graphite, although being the standard negative electrode in Li-ion batteries, is largely inactive for Na-ion storage in conventional non-aqueous carbonate-based electrolytes, for example. Very recently, it has been demonstrated that graphite can be activated for Na-ion storage in cells with ether-based electrolytes. The storage mechanism is based on co-intercalation of solvent molecules along with the Na-ions, forming ternary graphite intercalation compounds (t-GICs). This process is highly reversible but yet poorly understood. Here, we provide a comprehensive study on the formation and the stability of t-GICs. A series of ether solvents are being discussed: linear glymes with different chain lengths (mono-, di-, tri-, and tetraglyme), several derivatives with side groups as well as tetrahydrofuran (THF) as a cyclic ether and one crown ether. We show that the redox potentials shift depending on the ether chain length and mixing of ethers might enable tailoring of the redox behaviour. The inferior behaviour of triglyme is likely due to the less ideal ion coordination. Complementary experiments with lithium are made and demonstrate the superior behaviour of sodium. We find that the increase in graphene layer spacing during intercalation only slightly depends on the chain length and is in the range of 250%, and still mechanical stability is preserved. We further show the t-GICs possess chemical stability and demonstrate that the kinetically favoured charge transfer is probably due to the absence of a solid electrolyte interphase.

No abstract