In this work, the results of a detailed art technological investigation of the icon Last Supper from the Russian Memorial Church in Leipzig (Germany) are presented. The icons of the iconostasis of the church were made in the workshop of N.S. Emelyanov in Moscow in 1912. The investigation showed that the painter in principle technologically adhered to the traditional way of making icons. The panel is made of boards of lime wood with two crossbars on the reverse. The paint was applied to a chalk ground over a textile layer. The traditional iconographer's palette was expanded by a few contemporary pigments. The binding agent is classic egg tempera. Originally, the layers of paint had an oil varnish (olifa). The main aim of the project VirtEx, introduced in this paper, is to expand existing methods with numerical material and structural models to be able to predict quantitatively the behaviour of wooden artefacts under loads due to climate changes as well as mechanical loads. The detailed art technological investigation provides the required data for the computer models. The numerical data can then be validated with technologically exact copies and replicas. In the introduction to the article, the current state of research on icon painting techniques is also outlined.

This study presents the results of a double dome forming study for fiber reinforced thermoplastics to give an estimation about wrinkles size and fiber angle values. The parts were formed with an industry-oriented process at different forming temperatures and fiber directions (0 °/ 90 ° and ±45 °). They were formed without blank holder to allow wrinkling. The investigated material is a glass fiber –reinforced polyamide 6 with three layers of twill fabric (TEPEX® Dynalite 102-RG600(3)/47 %). The wrinkles are measured with a laser scanner. The shear angles were calculated using image analysis in MATLAB. It determines the fiber directions and calculates the fiber angles at their crossing points. Afterwards, areas with positive and negative shear angle values will be identified and discussed: These areas are in an axially symmetrical formation. At one side there are positive shear angles and on the other side there are negative shear angles. But results show, that absolute values differ. Furthermore, the results show, that shear angles increase with increasing forming temperatures and wrinkles size decrease. The results of this work will be used for the validation of FE forming models of double dome part in further studies.

Panels from laminated phenol-formaldehyde resin (PF) impregnated and compressed wood (Compreg) with top veneers from European species of beech, maple and white birch were prepared, each without or coated with resin pre-impregnated overlay papers. To clarify the outdoor resistance of Compreg surfaces, long-term artificial weathering experiments were performed. Weather-related color changes, gloss retention and microscopic and surface topographical surface alterations were examined. It has been observed that the application of PF impregnated paper overlays and combinations of them with melamine formaldehyde resin (MF) treated films significantly improved the weather resistance of Compreg surfaces. The extent of UV and moisture-induced surface damages of Compreg has been shown to also be dependent on the veneer types used as surface top layer. Highest surface and color stabilization against weather was achieved providing Compreg with top veneers from maple combined with PF overlays or applying both MF and PF impregnated overlay films as surface finish.