No abstract

No abstract

For sound absorption of conventional porous materials, its noise-reducing ability in low frequencies is less than that in high frequency bands. A porous layer offers effective sound absorption when the thickness of layer is a quarter wavelength of the sound wave. Increasing the layer thickness is not an effective solution. Adjustment of rear air cavity volume for the porous medium has been used in practical applications to increase low frequency sound absorption. Noise reduction using only passive sound absorption characteristics is a challenge, especially when the operation conditions of noise source changes. In this study, we propose a smart porous material having noise reduction ability in the broad frequency band. We implement semi-active control by applying a magnetic reactive material to a porous medium. The smart foam proposed in this study reduced noise with adjustment of the magnitude and polarity of the magnetic field. Evaluation of its noise reduction performance is performed with the impedance tube method. Experiments are conducted for semi-active noise control of the proposed smart foam. The sound absorption characteristics are controlled efficiently with relatively low electric power consumption. A theoretical model to predict absorption characteristics is proposed using the transfer-matrix method, and its results show good agreement with measured behaviors.

Organo-phosphorus compounds S 0080A Practical Method to Cleave Diphenyl Phosphonate Esters to Their Corresponding Phosphonic Acids in OneStep. -Diphenyl phosphonate esters (I) are prepared under mild conditions using NH4F in MeCN/water. The method is also suitable for nucleosides.

This paper presents a two-dimensional heat-exhaust and sound-proof acoustic meta-structure exhibiting tunable multi-band negative effective mass density. The meta-structure was composed of periodic funnel-shaped units in a square lattice. Each unit cell operates simultaneously as a Helmholtz resonator (HR) and an extended pipe chamber resonator (EPCR), leading to a negative effective mass density creating bandgaps for incident sound energy dissipation without transmission. This structure allowed large heat-flow through the cross-sectional area of the extended pipe since the resonance was generated by acoustic elements without using solid membranes. The pipes were horizontally directed to a flow source to enable small flow resistance for cooling. Measurements of the sound transmission were performed using a two-load, four-microphone method for a unit cell and small reverberation chamber for two-dimensional panel to characterize the acoustic performance. The effective mass density showed significant frequency dependent variation exhibiting negative values at the specific bandgaps, while the effective bulk modulus was not affected by the resonator. Theoretical models incorporating local resonances in the multiple resonator units were proposed to analyze the noise reduction mechanism. The acoustic meta-structure parameters to create broader frequency bandgaps were investigated using the theoretical model. The negative effective mass density was calculated to investigate the creation of the bandgaps. The effects of design parameters such as length, cross-sectional area, and volume of the HR; length and cross-sectional area of the EPCR were analyzed. To maximize the frequency band gap, the suggested acoustic meta-structure panel, small neck length, and cross-sectional area of the HR, large EPCR length was advantageous. The bandgaps became broader when the two resonant frequencies were similar.