One of the most harmful compounds are nitrogen oxides. Currently, the common industrial method of nitrogen oxides emission control is selective catalytic reduction with ammonia (NH3-SCR). Among all of the recognized measures, NH3-SCR is the most effective and reaches even up to 90% of NOx conversion. The presence of the catalyst provides the surface for the reaction to proceed and lowers the activation energy. The optimum temperature of the process is in the range of 150–450 °C and the majority of the commercial installations utilize vanadium oxide (V2O5) supported on titanium oxide (TiO2) in a form of anatase, wash coated on a honeycomb monolith or deposited on a plate-like structures. In order to improve the mechanical stability and chemical resistance, the system is usually promoted with tungsten oxide (WO3) or molybdenum oxide (MoO3). The efficiency of the commercial V2O5-WO3-TiO2 catalyst of NH3-SCR, can be gradually decreased with time of its utilization. Apart from the physical deactivation, such as high temperature sintering, attrition and loss of the active elements by volatilization, the system can suffer from chemical poisoning. All of the presented deactivating agents pass for the most severe poisons of V2O5-WO3-TiO2. In order to minimize the harmful influence of H2O, SO2, alkali metals, heavy metals and halogens, a number of methods has been developed. Some of them improve the resistance to poisons and some are focused on recovery of the catalytic system. Nevertheless, since the amount of highly contaminated fuels combusted in power plants and industry gradually increases, more effective poisoning-preventing and regeneration measures are still in high demand.

No abstract

Carbonaceous catalysts are promising materials for the low-temperature (< 523 K) process of NO reduction with ammonia. Based on literature and own experience of the authors, this review focuses on the possibilities to enhance their catalytic performance. It may be increased by the introduction of oxygen or nitrogen functionalities. So obtained materials may be used in SCR-NH 3 either as catalysts or supports for transition metals oxides/ hydroxides. Oxygen functionalities increase activity only to a small extent, but are necessary to prepare an efficient MeO x /AC catalyst. Nitrogen surface species lead to a considerable increase in DeNO x activity, as well as stability towards their oxidation to CO 2 . As the most efficient active components, oxides of V, Mn, Fe and Cu were found. H 2 O leads to the decrease of activity but for some catalysts additionally to the increase in selectivity. The understanding of SO 2 influence needs more experimental data. There still are several open questions concerning more detailed mechanistic studies, and especially the role of nitrogen functionalities, H 2 O and SO 2 .

MCM-22, MCM-36, and ITQ-2 zeolites with the intended Si/Al molar ratios of 15, 25, and 50 were synthetized and tested as catalysts for dehydration of methanol to dimethyl ether and dehydration of ethanol to diethyl ether and ethylene. The surface concentration of acid sites was regulated by the synthesis of zeolite precursors with different aluminum content in the zeolite framework, while the influence of porous structure on the overall efficiency of alcohol conversion was analyzed by application of zeolitic materials with different types of porosity—microporous MCM-22 as well as microporous-mesoporous MCM-36 and ITQ-2. The zeolitic samples were characterized with respect to their: chemical composition (ICP-OES), structure (XRD, FT-IR), texture (N2 sorption), and surface acidity (NH3-TPD). Comparison of the catalytic activity of the studied zeolitic catalysts with other reported catalytic systems, including zeolites with the similar Si/Al ratio as well as γ-Al2O3 (one of the commercial catalysts for methanol dehydration), shows a great potential of MCM-22, MCM-36, and ITQ-2 in the reactions of alcohols dehydration.

No abstract