No abstract

Calcium alginate beads entrapping a mixture of Fe(0) and nanosized magnetite (NMT) were prepared and evaluated for their capability to reduce nitrate in groundwater. Microscopic and spectroscopic analyses of the beads revealed that clusters of Fe(0)/NMT were entirely embedded in alginate polymer matrix containing a large number of carboxylic and hydroxyl functional groups. The extent of nitrate reduction increased with increasing content of Fe(0) and NMT in the beads, but there was a critical NMT mass limit relative to Fe(0) mass where no further increase in nitrate reduction occurred. The beads showed slower nitrate reduction kinetics than bare Fe(0)/NMT but had comparable capacity in overall nitrate removal. Nitrate reduction increased proportionally with an increase in bead dosage to give a maximum removal of 94.5 % at 37.5 g L −1 in 48 h. Nitrate reduction with 50 g L −1 beads achieved completion of two reduction cycles in 72 h to reduce 2.19 mM nitrate to less than 0.71 mM (10 mg-N L −1 ) in each cycle. The overall results demonstrated that the beads developed in this study have a potential utility in remediation of nitrate in groundwater.

No abstract

No abstract

In this study, a hydrogel impregnated with powder activated carbon (PAC), MAA-PAC, was synthesized through the polymerization of acrylic acid (AA) and PB was immobilized using the carboxyl group of AA. In this process, an adsorbent with an enhancement of PB content and stability of immobilization was developed through the additional supply of Fe3+ ions by the layer by layer (LBL) assembly. XRD, FT-IR, SEM (EDS), TEM (EDS, mapping), and TG analyzes of the LBL and non-LBL groups were performed to confirm the change of PB content in the adsorbent as the LBL assembly was applied. The stability of PB immobilization was confirmed during the washing process after the synthesis of the adsorbent. When the LBL assembly process was applied as a PB immobilization strategy, the PB content in the adsorbent was improved and PB leakage was not observed during the washing process. The maximum adsorption (qm) for cesium in the MAA-PAC-PB LBL group that showed high PB content was 40.03 mg/g, and the adsorption isotherm was more suitable for the Langmuir model than the Freundlich model. The LBL group showed a high removal efficiency of 99.81% and a high DF value (525.88) for radioactive cesium (120 Bq/g). These results demonstrate the potential efficiency of the MAA-PAC-PB LBL group for the decontamination of radioactive cesium-contaminated water systems. Furthermore, it was verified that the LBL group of MAA-PAC-PB could be used as an adsorbent without an additional design of the existing water treatment facility. This can an economical decontamination method for removing radioactive cesium.