Global climate models (GCMs) have limited capacity in simulating spatially non-uniform sea-level rise owing to their coarse resolutions and absence of tides in the marginal seas. Here, regional ocean climate models (RCMs) that consider tides were used to address these limitations in the Northwest Pacific marginal seas through dynamical downscaling. Four GCMs that drive the RCMs were selected based on a performance evaluation along the RCM boundaries, and the latter were validated by comparing historical results with observations. High-resolution (1/20°) RCMs were used to project non-uniform changes in the sea-level under intermediate (RCP 4.5) and high-end emissions (RCP 8.5) scenarios from 2006 to 2100. The predicted local sea-level rise was higher in the East/Japan Sea (EJS), where the currents and eddy motions were active. The tidal amplitude changes in response to sea-level rise were significant in the shallow areas of the Yellow Sea (YS). Dynamically downscaled simulations enabled the determination of practical sea-level rise (PSLR), including changes in tidal amplitude and natural variability. Under RCP 8.5 scenario, the maximum PSLR was ∼85 cm in the YS and East China Sea (ECS), and ∼78 cm in the EJS. The contribution of natural sea-level variability changes in the EJS was greater than that in the YS and ECS, whereas changes in the tidal contribution were higher in the YS and ECS. Accordingly, high-resolution RCMs provided spatially different PSLR estimates, indicating the importance of improving model resolution for local sea-level projections in marginal seas.

The tide‐induced residual current is a crucial determinant of the distribution of sediment in a tidally dominated bay. There have been only a few studies of residual currents in bays with laterally asymmetric depth, although the residual circulation in bays with symmetric lateral depth variation has been studied extensively. Gomso Bay is a typical bay with laterally asymmetric depth. The bay is characterized by a deep channel to the north and a wide shoal to the south. This study reports the tide‐induced residual current in Gomso Bay and explains its dynamics using numerical and analytical models. The results from the models are consistent with observations. Residual flows show a clockwise gyre inside the bay and counterclockwise circulation near the mouth. Three physical causes induce residual circulation: (1) bottom friction coupled with a tidal height, (2) advection causing inward residual transport, and (3) a pressure gradient due to a surface slope induced by subtidal flow. The maximum inward residual current is shifted toward the wider shoal. This is caused by across‐channel advection due to the laterally asymmetric depth.

Submarine groundwater discharge (SGD) plays an important role in coastal biogeochemical processes and hydrological cycles, particularly off volcanic islands in oligotrophic oceans. However, the spatial and temporal variations of SGD are still poorly understood owing to difficulty in taking rapid SGD measurements over a large scale. In this study, we used four airborne thermal infrared surveys (twice each during high and low tides) to quantify the spatiotemporal variations of SGD over the entire coast of Jeju Island, Korea. On the basis of an analytical model, we found a linear positive correlation between the thermal anomaly and squares of the groundwater discharge velocity and a negative exponential correlation between the anomaly and water depth (including tide height and bathymetry). We then derived a new equation for quantitatively estimating the SGD flow rates from thermal anomalies acquired at two different tide heights. The proposed method was validated with the measured SGD flow rates using a current meter at Gongcheonpo Beach. We believe that the method can be effectively applied for rapid estimation of SGD over coastal areas, where fresh groundwater discharge is significant, using airborne thermal infrared surveys.

Selecting a reliable global climate model as the driving forcing in simulations with dynamic downscaling is critical for obtaining a reliable regional ocean climate. With respect to their accuracy in providing physical quantities and long-term trends, we quantify the performances of 17 models from the Coupled Model Inter-comparison Project Phase 6 (CMIP6) over the North Pacific (NP) and Northwest Pacific (NWP) oceans for 1979–2014. Based on normalized evaluation measures, each model’s performance for a physical quantity is mainly quantified by the performance score (PS), which ranges from 0 to 100. Overall, the CMIP6 models reasonably reproduce the physical quantities of the driving variables and the warming ocean heat content and temperature trends. However, their performances significantly depend on the variables and region analyzed. The EC-Earth-Veg and CNRM-CM6-1 models show the best performances for the NP and NWP oceans, respectively, with the highest PS values of 85.89 and 76.97, respectively. The EC-Earth3 model series are less sensitive to the driving variables in the NP ocean, as reflected in their PS. The model performance is significantly dependent on the driving variables in the NWP ocean. Nevertheless, providing a better physical quantity does not correlate with a better performance for trend. However, MRI-ESM2-0 model shows a high performance for the physical quantity in the NWP ocean with warming trends similar to references, and it could thus be used as an appropriate driving forcing in dynamic downscaling of this ocean. This study provides objective information for studies involving dynamic downscaling of the NP and NWP oceans.