The aim of this study was to better understand the root causes for the (up to) 3 drug release phases observed with poly (lactic-co-glycolic acid) (PLGA) microparticles containing diprophylline particles: The 1 st release phase ("burst release"), 2 nd release phase (with an "about constant release rate") and 3 rd release phase (which is again rapid and leads to complete drug exhaust). The behavior of single microparticles was monitored upon exposure to phosphate buffer pH 7.4, in particular with respect to their drug release and swelling behaviors. Diprophylline-loaded PLGA microparticles were prepared with a solid-in-oil-inwater solvent extraction/evaporation method. Tiny drug crystals were rather homogeneously distributed throughout the polymer matrix after manufacturing. Batches with "small" (63 µm), "medium-sized" (113 µm) and "large" (296 µm) microparticles with a practical drug loading of 5-7 % were prepared. Importantly, each microparticle releases the drug "in its own way", depending on the exact distribution of the tiny drug crystals within the system. During the burst release, drug crystals with direct surface access rapidly dissolve. During the 2 nd release phase tiny drug crystals (often) located in surface near regions which undergo swelling, are likely released. During the 3 rd release phase, the entire microparticle undergoes substantial swelling. This results in high quantities of water present throughout the system, which becomes "gel-like". Consequently, the drug crystals dissolve, and the dissolved drug molecules rather rapidly diffuse through the highly swollen polymer gel.

No abstract