No abstract

Experimental results are presented for the overall heat transfer coefficient within an impingement/effusion wall, using a transient cooling technique. This was previously used for determining the effusion hole heat transfer alone. Two impingement/effusion geometries were used with an 8 mm gap and the same impingement wall with an X/D of 11. The separate impingement and effusion short hole heat transfer coefficients were also determined. The impingement/effusion overall heat transfer was 45% and 30% higher than the impingement heat transfer alone for the two test geometries. The greater increase was for the higher pressure loss effusion wall. It was shown that the combined heat transfer was predominantly the addition of the impingement and effusion heat transfer coefficients but the interaction effects were significant and resulted in an approximately 15% deterioration in the combined heat transfer coefficient. Overall film cooling effectiveness was obtained that showed a significant improvement with the addition of the impingement cooling, but still had a major effusion film cooling contribution.

The choice of hole diameter in impingement cooling requires the number of holes to be specified and design information is provided for this purpose. The correlations for impingement cooling usually take geometry effects into account by using the pitch-to-diameter ratio (X/D) and this is independent of the number of holes and specified purely by the desired pressure loss at a given flow rate. Impingement heat transfer from a square array of holes was studied for a range of coolant flows G from 0.1 to 1.8 kg/sm2 at a fixed X/D of approximately 10. The number of holes per unit surface area N was varied by a factor of 70 at a constant gap-to-hole diameter ratio Z/D of 4.5 and constant gaps of 3 mm and 10 mm. It was shown that there was a range of N over which there was only a small influence on heat transfer at constant G. However, heat transfer fell at large N due to crossflow effects and at low N due to inadequate surface coverage of the impingement flow.

No abstract

The wall heat transfer resulting from small diameter holes drilled at 90° through gas turbine combustion chamber and turbine blade walls is considered. Available information is briefly reviewed and shown to generally omit the hole approach surface heat transfer and to relate only to the internal hole heat transfer. Experimental techniques are described for the determination of the overall heat transfer in a metal plate with a large number of coolant holes drilled at 90°. The results are compared with conventional short-tube internal heat transfer measurements and shown to involve much higher heat transfer rates and this mainly resulted from the additional hole approach flow heat transfer.