Breeding values for dry matter intake (DMI) are important to optimize dairy cattle breeding goals for feed efficiency. However, generally, only small data sets are available for feed intake, due to the cost and difficulty of measuring DMI, which makes understanding the genetic associations between traits across lactation difficult, let alone the possibility for selection of breeding animals. However, estimating national breeding values through cheaper and more easily measured correlated traits, such as milk yield and liveweight (LW), could be a first step to predict DMI. Combining DMI data across historical nutritional experiments might help to expand the data sets. Therefore, the objective was to estimate genetic parameters for DMI, fat- and protein-corrected milk (FPCM) yield, and LW across the entire first lactation using a relatively large data set combining experimental data across the Netherlands. A total of 30,483 weekly records for DMI, 49,977 for FPCM yield, and 31,956 for LW were available from 2,283 Dutch Holstein-Friesian first-parity cows between 1990 and 2011. Heritabilities, covariance components, and genetic correlations were estimated using a multivariate random regression model. The model included an effect for year-season of calving, and polynomials for age of cow at calving and days in milk (DIM). The random effects were experimental treatment, year-month of measurement, and the additive genetic, permanent environmental, and residual term. Additive genetic and permanent environmental effects were modeled using a third-order orthogonal polynomial. Estimated heritabilities ranged from 0.21 to 0.40 for DMI, from 0.20 to 0.43 for FPCM yield, and from 0.25 to 0.48 for LW across DIM. Genetic correlations between DMI at different DIM were relatively low during early and late lactation, compared with mid lactation. The genetic correlations between DMI and FPCM yield varied across DIM. This correlation was negative (up to -0.5) between FPCM yield in early lactation and DMI across the entire lactation, but highly positive (above 0.8) when both traits were in mid lactation. The correlation between DMI and LW was 0.6 during early lactation, but decreased to 0.4 during mid lactation. The highest correlations between FPCM yield and LW (0.3-0.5) were estimated during mid lactation. However, the genetic correlations between DMI and either FPCM yield or LW were not symmetric across DIM, and differed depending on which trait was measured first. The results of our study are useful to understand the genetic relationship of DMI, FPCM yield, and LW on specific days across lactation.

To include feed-intake-related traits in the breeding goal, accurate estimates of genetic parameters of feed intake, and its correlations with other related traits (i.e., production, conformation) are required to compare different options. However, the correlations between feed intake and conformation traits can vary depending on the population. Therefore, the objective was to estimate genetic correlations between 6 feed-intake-related traits and 7 conformation traits within dairy cattle from 2 countries, the Netherlands (NL) and the United States (US). The feed-intake-related traits were dry matter intake (DMI), residual feed intake (RFI), milk energy output (MilkE), milk yield (MY), body weight (BW), and metabolic body weight (MBW). The conformation traits were stature (ST), chest width (CW), body depth (BD), angularity (ANG), rump angle (RA), rump width (RW), and body condition score (BCS). Feed intake data were available for 1,665 cows in NL and for 1,920 cows in US, from 83 nutritional experiments (48 in NL and 35 in US) conducted between 1991 and 2011 in NL and between 2007 and 2013 in US. Additional conformation records from relatives of the animals with DMI records were added to the database, giving a total of 37,241 cows in NL and 28,809 in US with conformation trait information. Genetic parameters were estimated using bivariate animal model analyses. The model included the following fixed effects for feed-intake-related traits: location by experiment-ration, age of cow at calving modeled with a second order polynomial by parity class, location by year-season, and days in milk, and these fixed effects for the conformation traits: herd by classification date, age of cow at classification, and lactation stage at classification. Both models included additive genetic and residual random effects. The highest estimated genetic correlations involving DMI were with CW in both countries (NL=0.45 and US=0.61), followed by ST (NL=0.33 and US=0.57), BD (NL=0.26 and US=0.49), and BCS (NL=0.24 and US=0.46). The MilkE and MY were moderately correlated with ANG in both countries (0.33 and 0.47 in NL, and 0.36 and 0.48 in US). Finally, BW was highly correlated with CW (0.77 in NL and 0.84 in US) and with BCS (0.83 in NL and 0.85 in US). Feed-intake-related traits were moderately to highly genetically correlated with conformation traits (ST, CW, BD, and BCS) in both countries, making them potentially useful as predictors of DMI.

Methane (CH) is a product of enteric fermentation in ruminants, and it represents around 17% of global CH emissions. There has been substantial effort from the livestock scientific community toward tools that can help reduce this percentage. One approach is to select for lower emitting animals. To achieve this, accurate genetic parameters and identification of the genomic basis of CH traits are required. Therefore, the objectives of this study were 1) to perform a genomewide association study to identify SNP associated with several CH traits in Angus beef cattle (1,020 animals) and validate them in a lactating Holstein population (population 1 [POP1]; 205 animals); 2) to validate significant SNP for DMI and weight at test (WT) from a second Holstein population, from a previous study (population 2 [POP2]; 903 animals), in an Angus population; and 3) to evaluate 2 different residual CH traits and determine if the genes associated with CH also control residual CH traits. Phenotypes calculated for the genotyped Angus population included CH production (MeP), CH yield (MeY), CH intensity (MI), DMI, and WT. The Holstein population (POP1) was multiparous, with phenotypes on CH traits (MeP, MeY, and MI) plus genotypes. Additionally, 2 CH traits, residual genetic CH (RGM) and residual phenotypic CH (RPM), were calculated by adjusting MeP for DMI and WT. Estimated heritabilities in the Angus population were 0.30, 0.19, and 0.15 for MeP, RGM, and RPM, respectively, and genetic correlations of MeP with DMI and WT were 0.83 and 0.80, respectively. Estimated heritabilities in Holstein POP1 were 0.23, 0.30, and 0.42 for MeP, MeY, and MI, respectively. Strong associations with MeP were found on chromosomes 4, 12, 14, 20, and 30 at < 0.001, and those chromosomes also had significant SNP for DMI in Holstein POP1. In the Angus population, the number of significant SNP for MeP at < 0.005 was 3,304, and approximately 630 of those SNP also were important for DMI and WT. When a set (approximately 3,300) of significant SNP for DMI and WT in the Angus population was used to estimate genetic parameters for MeP and MeY in Holstein POP1, the genetic variance and, consequently, the heritability slightly increased, meaning that most of the genetic variation is largely captured by these SNP. Residual traits could be a good option to include in the breeding goal, as this would facilitate selection for lower emitting animals without compromising DMI and WT.

Selecting for lower methane (CH 4 ) emitting animals is one of the best approaches to reduce CH 4 given that genetic progress is permanent and cumulative over generations. As genetic selection requires a large number of animals with records and few countries actively record CH 4 , combining data from different countries could help to expedite accurate genetic parameters for CH 4 traits and build a future genomic reference population. Additionally, if we want to include CH 4 in the breeding goal, it is important to know the genetic correlations of CH 4 traits with other economically important traits. Therefore, the aim of this study was first to estimate genetic parameters of 7 suggested methane traits, as well as genetic correlations between methane traits and production, maintenance, and efficiency traits using a multicountry database. The second aim was to estimate genetic correlations within parities and stages of lactation for CH 4 . The third aim was to evaluate the expected response of economically important traits by including CH 4 traits in the breeding goal. A total of 15,320 methane production (MeP, g/d) records from 2,990 cows belonging to 4 countries (Canada, Australia, Switzerland, and Denmark) were analyzed. Records on dry matter intake (DMI), body weight (BW), body condition score, and milk yield (MY) were also available. Additional traits such as methane yield (MeY; g/kg DMI), methane intensity (MeI; g/kg energy-cor-rected milk), a genetic standardized methane production, and 3 definitions of residual methane production (g/d), residual feed intake, metabolic BW (MBW), BW change, and energy-corrected milk were calculated. The estimated heritability of MeP was 0.21, whereas heritability estimates for MeY and MeI were 0.30 and 0.38, and for the residual methane traits heritability ranged from 0.13 to 0.16. Genetic correlations between different methane traits were moderate to high (0.41 to 0.97). Genetic correlations between MeP and economically important traits ranged from 0.29 (MY) to 0.65 (BW and MBW), being 0.41 for DMI. Selection index calculations showed that residual methane had the most potential for inclusion in the breeding goal when compared with MeP, MeY, and MeI, as residual methane allows for selection of low methane emitting animals without compromising other economically important traits. Inclusion of residual feed intake in the breeding goal could further reduce methane, as the correlation with residual methane is moderate and elicits a favorable correlated response. Adding a negative economic value for methane could facilitate a substantial reduction in methane emissions while maintaining an increase in milk production.

In dairy cattle, selecting for lower methane-emitting animals is one of the new challenges of this decade. However, genetic selection requires a large number of animals with records to get accurate estimated breeding values (EBV). Given that CH 4 records are scarce, the use of information on routinely recorded and highly correlated traits with CH 4 has been suggested to increase the accuracy of genomic EBV (GEBV) through multitrait (genomic) prediction. Therefore, the objective of this study was to evaluate accuracies of prediction of GEBV for CH 4 by including or omitting CH 4 , energy-corrected milk (ECM), and body weight (BW) as well as genotypic information in multitrait analyses across 2 methods: BLUP and single-step genomic BLUP (SSGBLUP). A total of 2,725 cows with CH 4 concentration in breath (14,125 records), BW (61,667 records), and ECM (61,610 records) were included in the analyses. Approximately 2,000 of these cows were genotyped or imputed to 50K. Ten cross-validation groups were formed by randomly grouping paternal half-sibs. Five scenarios were performed: (1) base scenario with only CH 4 information; (2) without CH 4 , but with information from BW, ECM, or BW+ECM only in reference population; (3) without CH 4 , but with information from BW, ECM, or BW+ECM in both validation and reference population; (4) with CH 4 information and BW, ECM, or BW+ECM information only in the reference population; and (5) with CH 4 information and BW, ECM, or BW+ECM information in both validation and reference population. As a result, for each method (BLUP, SSGBLUP), 13 sub-scenarios were performed, 1 from scenario 1, and 3 for each of the subsequent 4 scenarios. The average accuracy of GEBV for CH 4 in the base scenario was 0.32 for BLUP and 0.42 for SSGBLUP, and it ranged from 0.10 in scenario 2 to 0.78 in scenario 5 across methods. In terms of bias, the base scenario 1 was unbiased for SSGBLUP; similar results were achieved with scenario 5. Including information on ECM increased the accuracy of GEBV for CH 4 by up to 61%, whereas adding information on both traits (BW and ECM) increased the accuracy by up to 90%. Scenarios that did not include CH 4 in the reference population had the lowest correlations (0.17-0.33) with single-trait CH 4 GEBV, and scenarios with CH 4 in the reference population had the highest correlations (0.41-0.81). Thus, failure to include CH 4 in future reference populations results in predicted CH 4 GEBV, which cannot be used in practical selection. Therefore, recording CH 4 in more animals remains a priority. Finally, multiple-trait genomic prediction using routinely recorded BW and ECM leads to higher prediction accuracies than traditional single-trait genomic prediction for CH 4 and is a viable solution for increasing the accuracies of GEBV for scarcely recorded CH 4 in practice.