The future of lithium metal batteries as a widespread, safe and reliable form of high-energy-density rechargeable battery depends on a significant advancement in the electrolyte material used in these devices. Molecular solvent-based electrolytes have been superceded by polymer electrolytes in some prototype devices, primarily in a drive to overcome leakage and flammability problems, but these often exhibit low ionic conductivity and prohibitively poor lithium-ion transport. To overcome this, it is necessary to encourage dissociation of the lithium ion from the anionic polymer backbone, ideally without the introduction of competing, mobile ionic species. Here we demonstrate the effect of zwitterionic compounds, where the cationic and anionic charges are immobilized on the same molecule, as extremely effective lithium ion 'dissociation enhancers'. The zwitterion produces electrolyte materials with conductivities up to seven times larger than the pure polyelectrolyte gels, a phenomenon that appears to be common to a number of different copolymer and solvent systems.

No abstract

No abstract

Novel polymer electrolyte materials based on a polyelectrolyte‐in‐ionic‐liquid principle are described. A combination of a lithium 2‐acrylamido‐2‐methyl‐1‐propanesulfonic acid (AMPSLi) and N,N′‐dimethylacrylamide (DMMA) are miscible with the ionic liquid, 1‐ethyl‐3‐methylimidazolium dicyanamide (EMIDCA). EMIDCA has remarkably high conductivity (≥ 2 · 10−2 S · cm−1) at room temperature and acts as a good solvating medium for the polyelectrolyte. At compositions of AMPSLi less than or equal to 75 mol‐% in the copolymer (P(AMPSLi‐co‐DMAA)), the polyelectrolytes in EMIDCA are homogeneous, flexible elastomeric gel materials at 10 − 15 wt.‐% of total polyelectrolyte. Conductivities higher than 8 · 10−3 S · cm−1 at 30 °C have been achieved. The effects of the monomer composition, polyelectrolyte concentration, temperature and lithium concentration on the ionic conductivity have been studied using thermal and conductivity analysis, and pulsed field gradient nuclear magnetic resonance techniques.Comparison of the measured and calculated lithium conductivity at 30 °C.magnified imageComparison of the measured and calculated lithium conductivity at 30 °C.

␥-Radiation vulcanized natural rubber latex/phase transfer/bulk polymerization is a novel process for the preparation of toughened polystyrene based on natural rubber latex. The negatively charged ␥-radiation vulcanized natural rubber latex was first titrated with benzyldimethylhexadecylammonium chloride in the presence of a styrene monomer. At a critical transfer concentration, the crosslinked rubber particles transferred from the aqueous phase into the styrene phase in which they swelled, depending on the irradiation dose used. By bulk polymerization of the styrene phase containing transferred particles, the polymer blends exhibited two-phase morphology similar to that of commercial high-impact polystyrene that was microscopically obtained. The final product showed an increase in the unnotched Izod impact energy over the unmodified polystyrene. The effect of irradiation dose, rubber content, and initiator concentration on the impact property and morphology of toughened polystyrene prepared was investigated.