Excess summer milk and a lack of product diversity are major problems facing Taiwan's dairy goat industry. Gouda and Mozzarella cheeses made with cow milk are popular products for leisure farms in Taiwan, and they produce a large amount of cheese whey as waste. Our objective is to identify the unstable phenomena of pH-adjusted goat milk through the use of Turbiscan Lab ® Expert and to produce ricotta cheeses using cow cheese whey waste and excess goat milk. Delta backscattering (∆BS) profiles and the Turbiscan stability index (TSI) were used to evaluate the stability characteristics of goat milk adjusted to pH 6.7-5.2. The results show coagulation phenomena in skimmed goat milk and sedimentation phenomena in full-fat goat milk, when the pH was adjusted to 5.2. The TSI values of goat milk at pH 5.7 and 5.2 were significantly higher (p < 0.05) than that of a control. Therefore, 80/20 cow cheese whey/skimmed goat milk and 80/20 cow cheese whey/full-fat goat milk mixtures were acidified to pH 5.5 and heated at 90 • C for 30 min to produce ricotta cheeses A and B. The hardness value, moisture, protein, and ash contents of ricotta cheese A were significantly higher (p < 0.05) than that of ricotta cheese B, but no significant difference was found in terms of sensory evaluation.

An AOAC collaborative study was conducted to evaluate an affinity LC procedure for measuring immunoglobulin G (IgG) in selected dairy powders. The powders were extracted with 0.15 M sodium chloride solution and the pH was adjusted to 4.6 to precipitate caseins, which would otherwise lead to an overestimation of IgG. The analyte was then bound to a commercially available Protein G affinity cartridge and selectively eluted with a glycine buffer at pH 2.5. Detection was at 280 nm and quantification was made against a calibration curve prepared from bovine serum IgG. The samples analyzed included the likely matrixes for which this assay will find commercial use, namely, high- and low-protein-content colostrum powders, tablets containing colostrum powder, and some IgG-containing dairy powders; milk protein isolate, whey protein concentrate, and skim milk powder. Eleven laboratories provided data for the study and assayed blind duplicates of six materials. The repeatability RSD values ranged from 2.1 to 4.2 and the reproducibility RSD values ranged from 6.4 to 18.5. The Protein G method with casein removal has adequate reproducibility for measuring IgG in colostrum-derived powders that are traded on the basis of IgG content as a colostral marker.