A todos mis amigos del Departamento de Materiales. Gracias por hacer de cada día de trabajo una alegría. Con vosotros todo ha sido mucho más fácil. A Mariola, María José, Ana, Paula, Mariu, Belén, Tere y Nieves, mil gracias por los buenísimos momentos durante las comidas, en los despachos y en los laboratorios. También fuera de la universidad, ya fuera de fiesta o en la montaña, gracias al grupo de Materialitos:

Additive-free LTO ceramic anodes (thickness ∼500 μm) with high volumetric discharge capacity were prepared by powder extrusion moulding.

We report the preparation of thick ceramic electrodes of the olivine LiFePO (LFP) with high mass loading is reported. These electrodes are preparated by means of Powder Extrusion Moulding (PEM), which is a technology easily scalable and cheap. These LFP cathodes are additive-free (neither binder nor extra carbon black) with ~0.5 mm thickness, allowing to develop very high areal capacity (13.7 mA h cm -2 ). By means of a strict control of sintering process, the carbon coating of the commercial LFP powder remains and the decomposition of the active material is prevented. The optimized self-supported LFP cathode presents good cyclability over 20 cycles at C/10 with no capacity loss. The good electrochemical performance of these novel LFP thick electrodes and their non-flammability make them interesting candidates for both mobile and stationary applications.

New proton conducting membranes based on sulfonated polysulfone (sPSU) reinforced with TiO2(B) nanowires (1, 2, 5 and 10 wt.%) were synthesized and characterized. TiO2(B) nanowires were synthesized by means of a hydrothermal method by mixing TiO2 precursor in aqueous solution of NaOH as solvent. The presence of the TiO2(B) nanowires into the polymer were confirmed by means of Field Emission Scanning Electron Microscopy, Fourier transform infrared and X-ray diffraction. The thermal study showed an increase of almost 20 °C in the maximum temperature of sPSU backbone decomposition due to the presence of 10 wt.% TiO2(B) nanowires. Water uptake also is improved with the presence of hydrophilic TiO2(B) nanowires. Proton conductivity of sPSU with 10 wt.% TiO2(B) nanowires was 21 mS cm−1 (at 85 °C and 100% RH). Under these experimental conditions the power density was 350 mW cm−2 similar to the value obtained for Nafion 117. Considering all these obtained results, the composite membrane doped with 10 wt.% TiO2(B) nanowires is a promising candidate as proton exchange electrolyte in fuel cells (PEMFCs), especially those operating at high temperatures.