The primary inflorescence stem of Arabidopsis thaliana is rich in lignified cell walls, in both vascular bundles and interfascicular fibres. Previous gene expression studies demonstrated a correlation between expression of phenylpropanoid biosynthetic genes and a subset of genes encoding ATP-binding cassette (ABC) transporters, especially in the ABCB/multi-drug resistance/P-glycoprotein (ABCB/MDR/PGP) and ABCG/pleiotropic drug resistance (ABCG/PDR) subfamilies. The objective of this study was to characterize these ABC transporters in terms of their gene expression and their function in development of lignified cells. Based on in silico analyses, four ABC transporters were selected for detailed investigation: ABCB11/MDR8, ABCB14/MDR12, ABCB15/MDR13, and ABCG33/PDR5. Promoter::glucuronidase reporter assays for each gene indicated that promoters of ABCB11, ABCB14, ABCB15, and ABCG33 transporters are active in the vascular tissues of primary stem, and in some cases in interfascicular tissues as well. Homozygous T-DNA insertion mutant lines showed no apparent irregular xylem phenotype or alterations in interfascicular fibre lignification or morphology in comparison with wild type. However, in abcb14-1 mutants, stem vascular morphology was slightly disorganized, with decreased phloem area in the vascular bundle and decreased xylem vessel lumen diameter. In addition, abcb14-1 mutants showed both decreased polar auxin transport through whole stems and altered auxin distribution in the procambium. It is proposed that both ABCB14 and ABCB15 promote auxin transport since inflorescence stems in both mutants showed a reduction in polar auxin transport, which was not observed for any of the ABCG subfamily mutants tested. In the case of ABCB14, the reduction in auxin transport is correlated with a mild disruption of vascular development in the inflorescence stem.
To try to improve hydrolysis yields at elevated solids loadings, a comparison was made between batch and fed-batch addition of fresh substrate at the initial and later phases of hydrolysis. Both ethanol (EPCS) and steam-pretreated corn stover (SPCS) substrates were tested at low (5 FPU) and high (60 FPU) loadings of cellulase per gram of cellulose. The fed-batch addition of fresh substrate resulted in a slight decrease in hydrolysis yields when compared with the corresponding batch reactions. A 72-h hydrolysis of the SPCS substrate resulted in a hydrolysis yield of 66% compared with 51% for the EPCS substrate. When the enzyme adsorption and substrate characteristics were assessed during batch and fed-batch hydrolysis, it appeared that the irreversible binding of cellulases to the more recalcitrant original substrate limited their access to the freshly added substrate. After 72-h hydrolysis of the SPCS substrate at low enzyme loadings, ∼40-50% of the added cellulases were desorbed into solution, whereas only 20% of the added enzyme was released from the EPCS substrate. Both simultaneous and sequential treatments with xylanases and cellulases resulted in an up to a 20% increase in hydrolysis yields for both substrates at low enzyme loading. Simons' stain measurements indicated that xylanase treatment increased cellulose access, thus facilitating cellulose hydrolysis.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
customersupport@researchsolutions.com
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.