Hydroxyapatite nanoscale particles (nHA) were prepared by wet chemical precipitation using four different synthesis methods. Differences in physico-chemical properties including morphology, particle-size, and crystallinity were investigated following alteration of critical processing parameters. The nanoparticles were also studied using X-ray diffraction (XRD), Fourier Transform infrared spectroscopy in attenuated total reflectance mode (FTIR-ATR), and transmission electron microscopy (TEM) with energy dispersive X-ray (EDS) spectrometry. The results showed that the particles obtained were composed of nHA, with different morphologies and aspect ratios (1.5 to 4) and degrees of crystallinity (40% to 70% following calcination) depending on the different process parameters of the synthesis method used, such as temperature, ripening time and pH. This study demonstrated that relatively small adjustments to processing conditions of different wet chemical preparation methods significantly affect the morphological and chemical characteristics of nHA. For the predicable preparation of biomimetic nHA for specific applications, the selection of both production method and careful control of processing conditions are paramount.

No abstract

Hydroxyapatite (HA) has been widely used as a medical ceramic due to its good biocompatibility and osteoconductivity. Recently there has been interest regarding the use of bioinspired nanoscale hydroxyapatite (nHA). However, biological apatite is known to be calcium-deficient and carbonate-substituted with a nanoscale platelet-like morphology. Bioinspired nHA has the potential to stimulate optimal bone tissue regeneration due to its similarity to bone and tooth enamel mineral. Many of the methods currently used to fabricate nHA both in the laboratory and commercially, involve lengthy processes and complex equipment. Therefore, the aim of this study was to develop a rapid and reliable method to prepare high quality bioinspired nHA. The rapid mixing method developed was based upon an acid-base reaction involving calcium hydroxide and phosphoric acid. Briefly, a phosphoric acid solution was poured into a calcium hydroxide solution followed by stirring, washing and drying stages. Part of the batch was sintered at 1,000 °C for 2 h in order to investigate the products' high temperature stability. X-ray diffraction analysis showed the successful formation of HA, which showed thermal decomposition to β-tricalcium phosphate after high temperature processing, which is typical for calcium-deficient HA. Fourier transform infrared spectroscopy showed the presence of carbonate groups in the precipitated product. The nHA particles had a low aspect ratio with approximate dimensions of 50 x 30 nm, close to the dimensions of biological apatite. The material was also calcium deficient with a Ca:P molar ratio of 1.63, which like biological apatite is lower than the stoichiometric HA ratio of 1.67. This new method is therefore a reliable and far more convenient process for the manufacture of bioinspired nHA, overcoming the need for lengthy titrations and complex equipment. The resulting bioinspired HA product is suitable for use in a wide variety of medical and consumer health applications.

Hydroxyapatite and fluorhydroxyapatite (F)HA nanoparticles were synthesised in the presence of branched poly(acrylic acid)s and compared to those synthesised in the presence of linear PAA.

No abstract