Dry fractionated legume protein ingredients are gaining attention as alternatives to conventional solvent extracted legume proteins, being more resource efficient and often exhibiting novel functional properties. However, lack of knowledge about the relationship between composition and functionality limit a more wide-spread use of dry-fractionated legume protein in applications. In this study, lentil fractions of different degrees of refinement were prepared using air classification having protein and starch contents of 16–59% and 4–64%, respectively. The dry fractionated lentil fractions could emulsify and stabilize 10 wt% oil-in-water emulsions, while a conventional lentil protein isolate used for comparison was not able to form stable emulsions. The latter had significantly larger mean droplet diameters (around 20 µm) due to droplet flocculation than emulsions made with the different lentil fractions ranging between 0.3 and 5.5 µm. Similar surface charges (between −22 and −31 mV) indicated that the discrepancy could be ascribed to differences in steric repulsion and mechanical strength of the interfacial layers between conventionally and dry fractionated lentil. Storage stability tests of emulsions stabilized with dry fractionated samples resulted in separation into a low and higher density phase with the individual droplets being stable against coalescence in both phases. The phase separation was attributed to gravimetrical sedimentation of larger insoluble components accumulating in the denser phase, which was impacted by the degree of refinement by air classification. The results highlight the potential of dry fractionation for the production of sustainable ingredients with unique composition and functionality.

Ultrasonic spectrometry was used to distinguish between properly tempered and untempered commercial dark chocolate. X-ray diffraction (XRD) and differential scanning calorimetry (DSC) were used to characterize the polymorphic state of tempered and untempered chocolate, results that were correlated to those of ultrasonic spectrometry. Four different kinds of dark chocolate samples with different amounts of sugar (7.5-50 %), fat (30-50 %), and cocoa mass (70-90 %) were subjected to two different tempering protocols. The tempering was achieved using cocoa butter seeds under static cooling from 50 to 14°C. The ultrasonic generator and analyzer SIA-7 (V.N. Instruments) was used to monitor the crystallization process. The instrument generated a chirp signal with a bandwidth of 0.5 to 3 MHz and was set to work in a four-pathway configuration with two transducers and a center frequency of 2.25 MHz. Spectrometric analysis was carried out with chocolate samples containing 2, 4, and 6 % solid fat content (SFC). The SFC was obtained from DSC measurements. Ultrasonic signals for attenuation, reflection, and velocity were compared between tempered and untempered chocolates. It was shown that seed-tempered chocolate with 30 % sugar and 47.5 % fat attenuated 2.5 MHz of ultrasonic waves by 0.8, 1.7, and 2.0 dB/cm at 2, 4, and 6 % SFC, respectively. On the other hand, untempered chocolate attenuated the ultrasound signal by 3.5, 3.6, and 4.3 dB/cm. Furthermore, it was found that ultrasound reflection signals were stronger and ultrasonic velocity was higher in chocolates with high sugar content.