No abstract

No abstract

The aim of this paper was to show how the shape of sand particles affects the results of particle size distribution obtained by the laser diffraction method. On the basis of the results obtained one can conclude: the shape of the investigated particles influences particle size distribution obtained by the laser diffraction method. This phenomenon occurs in the sand fraction, as shown in our investigation. The importance of this effect depends on the type of the measured material and on the aim of the investigations. For most researchers in soil science and sedimentology who investigate sand fractions, this impact can be negligible. Further investigations with other soil and sediment fractions are needed.

No abstract

One of the methods for testing splash (the first phase of water erosion) may be an analysis of photos taken using so-called high-speed cameras. The aim of this study was to determine the reproducibility of measurements using a single drop splash of simulated precipitation. The height from which the drops fell resulted in a splash of 1.5 m. Tests were carried out using two types of soil: Eutric Cambisol (loamy silt) and Orthic Luvisol (sandy loam); three initial pressure heads were applied equal to 16 kPa, 3.1 kPa, and 0.1 kPa. Images for one, five, and 10 drops were recorded at a rate of 2000 frames per second. It was found that (i) the dispersion of soil caused by the striking of the 1st drop was significantly different from the splash impact caused by subsequent drops; (ii) with every drop, the splash phenomenon proceeded more reproducibly, that is, the number of particles of soil and/or water that splashed were increasingly close to each other; (iii) the number of particles that were detached during the splash were strongly correlated with its surface area; and (iv) the higher the water film was on the surface the smaller the width of the crown was.