Periprosthetic joint infection (PJI) is a serious complication after arthroplasty, which is associated with pain, prolonged hospital stay, multiple surgeries, functional incapacitation, and even mortality. Using scientific and efficient management protocol including modern diagnosis and treatment of PJI and eradication of infection is possible in a high percentage of affected patients. In this article, we review the current knowledge in epidemiology, classification, pathogenesis, diagnosis and treatment of PJI.

Three-dimensional (3D) electrodes have been demonstrated to be promising candidates for high-performance supercapacitors because of their unique architectures and outstanding electrochemical properties. However, the fabrication process for current 3D electrodes is not scalable. Herein, a novel and cost-effective activation process has been developed to macroscopically produce 3D porous Ni@NiO core-shell electrodes with enhanced electrochemical properties. The porous Ni@NiO core-shell electrode obtained by activated commercial Ni foam (NF) in a 3 M HCl solution yields an ultrahigh areal capacitance of 2.0 F cm À2 at a high current density of 8 mA cm À2 , which is substantially higher than that of most reported 3D NF-based electrodes. Moreover, the activated NF (ANF) electrode exhibited super-long cycling stability. Owing to the increased accessible surface area and continual formation of electrochemically active NiO during cycling, the areal capacitance of the ANF electrode did not exhibit any decay and instead increased from 0.47 to 1.27 F cm À2 after 100 000 cycles at 100 mV s À1 . This is the best cycling stability achieved by a 3D NF-based electrode. Additionally, a high-performance asymmetrical supercapacitor (ASC) device based on the as-prepared ANF cathode and a reduced graphene oxide (RGO) anode was also prepared. The ANF//RGO-ASC device was able to deliver a maximum energy density of 1.06 mWh cm À3 and a maximum power density of 0.42 W cm À3 .

In this paper, we reported an effective and simple strategy to prepare large areal mass loading of MnO2 on porous graphene gel/Ni foam (denoted as MnO2/G-gel/NF) for supercapacitors (SCs). The MnO2/G-gel/NF (MnO2 mass: 13.6 mg cm(-2)) delivered a large areal capacitance of 3.18 F cm(-2) (234.2 F g(-1)) and good rate capability. The prominent electrochemical properties of MnO2/G-gel/NF are attributed to the enhanced conductivities and improved accessible area for ions in electrolytes. Moreover, an asymmetric supercapacitor (ASC) based on MnO2/G-gel/NF (MnO2 mass: 6.1 mg cm(-2)) as the positive electrode and G-gel/NF as the negative electrode achieved a remarkable energy density of 0.72 mW h cm(-3). Additionally, the fabricated ASC device also exhibited excellent cycling stability, with less than 1.5% decay after 10,000 cycles. The ability to effectively develop SC electrodes with high mass loading should open up new opportunities for SCs with high areal capacitance and high energy density.