The electrooptical characteristics of carbon nanotube-doped liquid crystal (LC) devices were investigated. Two complementary operation modes of the liquid crystal cells were fabricated. The measured results reveal that anisotropic carbon nanosolids modify the dielectric anisotropy and the viscosity of the liquid crystal carbon nanotube mixture, hence significantly modifying the threshold voltage and the switching behavior of a liquid crystal device. Doping a small amount of carbon nanotubes into the liquid crystal mixture is effective in improving the electrooptical characteristics of an LC device when the employed LC mixture is viscous.

No abstract

We investigated the electrooptical properties of a carbon nanotube (CNT)-doped twisted nematic (TN) liquid crystal (LC) cell. Experimental results reveal that the doped CNTs influence the elastic constant of LC–CNT dispersion. Using a small amount of CNT dopant, the field-on response time of the LC cell is nearly invariant; the threshold voltage of the cell increases due to the increase in the elastic constant of LC–CNT dispersion. At a higher CNT concentration, the marked increase in the dielectric anisotropy of LC–CNT dispersion markedly decreases the field-on response time and threshold voltage of the LC cell. The field-off response time of this cell decreases with increasing CNT concentration due to the increase in elastic constant and the slight increase in viscosity of LC–CNT dispersion. The field-on and field-off response times of the LC cell are reduced simultaneously when the LC host is doped with a moderate amount of CNT dopant.

The effects of ultraviolet (UV) irradiation on the work function of poly(3,4-ethylenedioxythiophene) doped with poly(4-styrenesulfonate) (PEDOT:PSS) have been investigated in this study. Spectroscopic methods [x-ray photoelectron spectroscopy and Raman spectroscopy (532nm excitation)] and electrical conductivity measurements were used to characterize the electrical conducting polymer PEDOT:PSS prepared by UV irradiation. The authors found that UV irradiation could lead to an increase in the work function and the enhancement of electrical conductivity of PEDOT:PSS, resulting from a decrease in the number of the charge-trapping-related defects and the formation of linear or expanded-coil conformation.

The dynamic pattern formation and the beam-steering characteristics of cholesteric gratings were studied. Films with a planar cholesteric texture and various thickness to pitch length ratios (d/p) were fabricated. An optical microscope was used to observe the stripe patterns of the cholesteric gratings formed by applying a voltage to the planar films. The micrographs showed that the cholesteric gratings were formed in two different ways, depending on the sample's d/p ratio. For samples with 1/2≤d/p≤1.0, the grating stripes simultaneously appeared across the whole sample, and the contrast of the stripes increased with time during formation. For films with d/p≥1.5, the stripes were initiated near the edges, and near the defects on the substrates, and then slowly extended to the whole sample along the rubbing direction. The diffraction measurements showed that the diffracted beams could be steered either electrically or optically only for the latter type of film. These results can be well explained theoretically.