BackgroundCourse setting has often been discussed as a potential preventative measure in the World Cup ski-racing community. However, there is limited understanding of how it is related to injury risk.ObjectiveThis study was undertaken to investigate the effect of increased horizontal gate distance on energy-related and injury mechanism-related variables.MethodsDuring a video-based three-dimensional (3D)-kinematic field measurement, a top world-class racer performed giant slalom runs at two course settings with different horizontal gate distances. A full-body segment model was reconstructed in 3D and selected biomechanical parameters were calculated.ResultsFor the analysed turn, no significant differences were found in turn speed for increased horizontal gate distance. However, a large effect size was observed for speed reduction towards the end of the turn. Turn forces were by tendency higher at the beginning and significantly higher towards the end of the turn. Additionally, significant differences were found in higher inward leaning, and large effect sizes were observed for a decreased fore/aft position after gate passage.ConclusionsOn the basis of the data of this study, no final conclusion can be made about whether, for a section of consecutive turns, increasing horizontal gate distance is an effective tool for speed reduction. However, this study pointed out two major drawbacks of this course setting modification: (1) it may increase fatigue as a consequence of loading forces acting over a longer duration; (2) it may increase the risk of out-of-balance situations by forcing the athlete to exhaust his backward and inward leaning spectrum.

In the laboratory, optoelectronic stereophotogrammetry is one of the most commonly used motion capture systems; particularly, when position- or orientation-related analyses of human movements are intended. However, for many applied research questions, field experiments are indispensable, and it is not a priori clear whether optoelectronic stereophotogrammetric systems can be expected to perform similarly to in-lab experiments. This study aimed to assess the instrumental errors of kinematic data collected on a ski track using optoelectronic stereophotogrammetry, and to investigate the magnitudes of additional skiing-specific errors and soft tissue/suit artifacts. During a field experiment, the kinematic data of different static and dynamic tasks were captured by the use of 24 infrared-cameras. The distances between three passive markers attached to a rigid bar were stereophotogrammetrically reconstructed and, subsequently, were compared to the manufacturer-specified exact values. While at rest or skiing at low speed, the optoelectronic stereophotogrammetric system’s accuracy and precision for determining inter-marker distances were found to be comparable to those known for in-lab experiments (< 1 mm). However, when measuring a skier’s kinematics under “typical” skiing conditions (i.e., high speeds, inclined/angulated postures and moderate snow spraying), additional errors were found to occur for distances between equipment-fixed markers (total measurement errors: 2.3 ± 2.2 mm). Moreover, for distances between skin-fixed markers, such as the anterior hip markers, additional artifacts were observed (total measurement errors: 8.3 ± 7.1 mm). In summary, these values can be considered sufficient for the detection of meaningful position- or orientation-related differences in alpine skiing. However, it must be emphasized that the use of optoelectronic stereophotogrammetry on a ski track is seriously constrained by limited practical usability, small-sized capture volumes and the occurrence of extensive snow spraying (which results in marker obscuration). The latter limitation possibly might be overcome by the use of more sophisticated cluster-based marker sets.

No abstract