Phosphorus (P) adsorption capacities of materials derived from batch experiments can vary by several orders of magnitude depending on the method used, leading to potential misinterpretation of the P retention capacity on a long-term basis and unrealistic estimations of constructed wetland systems (CWS) longevity. The objective of this study was to determine if the P saturation of the material in a column could be used for this purpose with an improved accuracy. A 278-d column experiment with a synthetic P solution was conducted to investigate the long-term P retention capacity of electric arc furnace (EAF) steel slag up to its P saturation point. EAF slag showed a high affinity for P, reaching a saturation value of 1.35 g of P kg(-1). Investigations of the regeneration of the P adsorbing capacity by this material showed that, after 4 weeks of water desaturated resting, EAF steel slag was able to increase its initial P adsorptive capacity to 2.35 g of P kg(-1). A sequential P fractionation experiment was performed to quantify the proportion of P bound to mineral compounds in EAF. From the most loosely bound to the most strongly bound P fraction, P was associated with resin extractable (14%), Fe extractable (0.5 M Na2CO3, 47%), Al extractable (0.1 M NaOH, 1%), Ca extractable (1 M HCl, 12%), and Ca in a stable residual pool (concentrated hot HCl, 26.5%). X-ray fluorescence analyses of EAF steel slag chemical composition revealed that the continuous application of a P solution resulted in 75% and 59% increases in K2O and P2O5 respectively; Al2O3 and FeO increased by 8%, while the portion of CaO remained unchanged. The investigated properties (P retention potential, regeneration of P adsorption, P fractionation) provide useful data about the suitability of slag material as a media for long-term P removal and should enable an improved prediction of the longevity of full-scale CWS.

No abstract

Freshwater trout farms need a high and continuous clean water flow to keep fish exposed to a non-toxic ammonium concentration. As a result, the concentration of effluents from these farms are even below standard effluent criteria for municipal wastewater effluent for solids, nitrogen and phosphorus. Nevertheless, the mass of pollutants discharged, originating mostly from excreta and undigested fish food, must be reduced by simple and economical treatment processes. We designed and operated a three-stage system aimed at retaining solids by a 60 pm nylon rotating microscreen followed by treatment with a phosphorus-retaining constructed wetland system. Washwater from the microscreen was pumped to a series of two horizontal flow beds of 100 m3 each (0.6 m deep). Coarse (2 mm) and finer (< 2 mm) crushed limestone were used in each bed, respectively, with the first one being planted with reeds (Phragmites australis) and the second one designed to remove even more phosphorus by adsorption and precipitation. Preliminary results indicated that the microscreen captured about 60% of the suspended solids and that greater than 95% of the suspended solids and greater than 80% of the total phosphorus mass loads were retained by the beds. The potential of constructed wetlands as an ecologically attractive and economical method for treating fish farm effluents to reduce solids and phosphorus discharge appears promising.