The corrosion of zero-valent iron (Fe0(s)) by oxygen (O2) can lead to the oxidation of organic compounds. To gain insight into the reaction mechanism and to assess the nature of the oxidant, the oxidation of methanol, ethanol, 2-propanol, and benzoic acid by the reaction of nanoparticulate zero-valent iron (nZVI) or ferrous iron (Fe[II]) with O2 in the absence of ligands was studied. At pH values below 5, Fe0(s) nanoparticles were oxidized by O2 within 30 min with a stoichiometry of approximately two Fe0(s) oxidized per O2 consumed. The yield of methanol and ethanol oxidation products increased from 1% at acidic pH to 6% at pH 7, relative to nZVI added. Product yields from 2-propanol and benzoic acid were highest under acidic conditions, with little oxidation observed at neutral pH. At pH values below 5, product formation was attributable to hydroxyl radical (OH.) production through the Fenton reaction, involving hydrogen peroxide and Fe(II) produced during nZVI oxidation. At higher pH values, the oxidation of Fe(II), the initial product of nZVI oxidation, by oxygen is responsible for most of the oxidant production. Product yields at circumneutral pH values were consistent with a different oxidant, such as the ferryl ion (Fe[IV]).

The reaction of zero-valent iron or ferrous iron with oxygen produces reactive oxidants capable of oxidizing organic compounds. However, the oxidant yield in the absence of ligands is too low for practical applications. The addition of oxalate, nitrilotriacetic acid (NTA), or ethylenediaminetetraacetic acid (EDTA) to oxygen-containing solutions of nanoparticulate zero-valent iron (nZVI) significantly increases oxidant yield, with yields approaching their theoretical maxima near neutral pH. These ligands improve oxidant production by limiting iron precipitation and by accelerating the rates of key reactions, including ferrous iron oxidation by oxygen and hydrogen peroxide. Product yields indicate that the oxic nZVI system produces hydroxyl radical (OH·) over the entire pH range in the presence of oxalate and NTA. In the presence of EDTA, probe compound oxidation is attributed to OH· under acidic conditions and a mixture of OH· and ferryl ion (Fe[IV]) at circumneutral pH.

To identify the mechanism through which nanoparticulate zero-valent iron (nZVI; Fe0(s)) damages cells, a series of experiments were conducted in which nZVI in phosphate-buffered saline (PBS) was exposed to oxygen in the presence and absence of human bronchial epithelial cells. When nZVI is added to PBS, a burst of oxidants is produced as Fe0 and ferrous iron (Fe[II]) are converted to ferric iron (Fe[II]). Cytotoxicity and internal reactive oxygen species (ROS) production in cells exposed to nZVI is equivalent to the response observed when cells are exposed to the same concentration of dissolved Fe(II). Experiments conducted in the absence of cells indicate that the oxidant produced during Fe(II) oxidation reacts with methanol and dimethyl sulfoxide, but not with compounds such as tert-butanol and benzoate that react exclusively with hydroxyl radical. The role of reactive oxidants produced during Fe(II) oxidation in cytotoxicity and internal ROS production is further supported by experiments in which cell damage was limited by the addition of ligands that prevented Fe(II) oxidation and by the absence of cell damage when the nanoparticles were oxidized prior to exposure. The behavior of the oxidant produced by nZVI is consistent with an oxidant such as the ferryl ion, rather than hydroxyl radical.

In the presence of oxygen, organic compounds can be oxidized by zero-valent iron or dissolved Fe (II). However, this process is not a very effective means of degrading contaminants because the yields of oxidants are usually low (i.e., typically less than 5% of the iron added is converted into oxidants capable of transforming organic compounds). The addition of polyoxometalate (POM) greatly increases the yield of oxidants in both systems. The mechanism of POM enhancement depends on solution pH. Under acidic conditions, POM-mediates the electron transfer from nanoparticulate zerovalent iron (nZVI) or Fe(II) to oxygen, increasing the production of hydrogen peroxide, which is subsequently converted to hydroxyl radical through the Fenton reaction. At neutral pH values, iron forms a complex with POM, preventing iron precipitation on the nZVI surface and in bulk solution. At pH 7, the yield of oxidant approaches the theoretical maximum in the nZVI/O 2 and the Fe(II)/ O 2 systems when POM is present, suggesting that coordination of iron by POM alters the mechanism of the Fenton reaction by converting the active oxidant from ferryl ion to hydroxyl radical. Comparable enhancements in oxidant yields are also observed when nZVI or Fe(II) are exposed to oxygen in the presence of silica-immobilized POM.

Solar disinfection, or SODIS, shows tremendous promise for point-of-use drinking water treatment in developing countries, but can require 48 h or more for adequate disinfection in cloudy weather.In this research, we show that a number of low-cost additives are capable of accelerating SODIS.These additives included 100-1000 mM hydrogen peroxide, both at room temperature and at elevated temperatures, 0.5 -1% lemon and lime juice, and copper metal or aqueous copper plus ascorbate, with or without hydrogen peroxide. Laboratory and field experiments indicated that additives might make SODIS more rapid and effective in both sunny and cloudy weather, developments that could help make the technology more effective and acceptable to users.