Normal and electrically stimulated PC12 cell cultures and the implantation of nerve guidance channels were performed to evaluate newly developed electrically conductive biodegradable polymer composites. Polypyrrole (PPy) doped by butane sulfonic acid showed a significantly higher number of viable cells compared with PPy doped by polystyrenesulfonate after a 6-day culture. The PC12 cells were left to proliferate for 6 days, and the PPy-coated membranes, showing less initial cell adherence, recorded the same proliferation rate as did the noncoated membranes. Direct current electricity at various intensities was applied to the PC12 cell-cultured conductive membranes. After 7 days, the greatest number of neurites appeared on the membranes with a current intensity approximating 1.7-8.4 microA/cm. Nerve guidance channels made of conductive biodegradable composite were implanted into rats to replace 8 mm of sciatic nerve. The implants were harvested after 2 months and analyzed with immunohistochemistry and transmission electron microscopy. The regenerated nerve tissue displayed myelinated axons and Schwann cells that were similar to those in the native nerve. Electrical stimulation applied through the electrically conductive biodegradable polymers therefore enhanced neurite outgrowth in a current-dependent fashion. The conductive polymers also supported sciatic nerve regeneration in rats.

This study evaluated the in vivo biocompatibility and biodegradation behavior of a novel polypyrrole (PPy)/poly(D,L-lactide) (PDLLA) composite and PPy-coated poly(D,L-lactide-co-glycolide) membranes. Test membranes were implanted subcutaneously in rats for 3-120 days. The biocompatibility was assessed by quantifying the alkaline and acid phosphatase secretion, the immunohistochemical staining of the ED-2-positive macrophages, and the histology at the tissue/material interface. The degradation was investigated using scanning electron microscopy. Pure PDLLA and poly(D,L-lactide-co-glycolide) membranes were used as references, whereas expanded polytetrafluoroethylene and a commercial styrene-butadiene rubber were used as controls. The enzyme activity of the PPy-containing specimens was shown to be similar to that of the references. The histological findings were consistent with the enzymatic results, showing a mild-to-moderate acute inflammation followed by a resolution of the inflammatory response with a decrease in inflammatory cells for each biodegradable membrane. The tissue reactions to the PPy, which was either in the form of nanoparticles or surface coating, were comparable to the response to the neighboring biodegradable materials. Elevated ED-2-positive macrophage populations appeared as early as day 3 in the loose connective tissue surrounding the implants. The density of these populations was related to the degree of inflammation. Scanning electron microscopy showed that the degradation of the PPy/PDLLA composite was not affected by the presence of PPy.

The electrical stability of a novel polypyrrole (PPy)/poly(D,L-lactide) (PDLLA) composite was studied in vitro and compared with that of PPy-coated polyester fabrics. Specimens were incubated in Ringer's solution at 37 degrees C for up to 8 weeks with or without the circulation of DC current under a constant 100 mV voltage. In situ current variation with incubation time was recorded. The AC volume electrical conductivity of the specimens before and after incubation in phosphate-buffered saline was recorded using a frequency analyzer. Water absorption and weight loss were monitored metrologically. Changes in the oxidation state of incubated PPy were analyzed with X-ray photoelectron spectroscopy. The morphological changes were observed with scanning electron microscopy, and the glass transition temperature of the PDLLA was investigated using differential scanning calorimetry. The PPy/PDLLA composite in Ringer's solution sustained a relatively stable conductivity up to 8 weeks after an initial period of "conditioning." The PPy-coated fabrics experienced a rapid loss of conductivity when subjected to electrical circulation and regained part of it when disconnected. The volume conductivity of the nonincubated PPy/PDLLA membrane behaved as a typical conductor in the low-frequency range. The mechanisms involved in the various electrical behaviours of the PPy/PDLLA composite and PPy-coated fabrics are discussed. In conclusion, the PPy/PDLLA composite was able to deliver a biologically significant electrical current in a simulated biological solution for up to 8 weeks and therefore may be considered as a first-generation synthetic biodegradable bioconductor.

Biomimetic hydrogel made of poly(ethylene glycol) and soy protein with a water content of 96% has been developed for moist wound dressing applications. In this study, such hybrid hydrogels were investigated by both tensile and unconfined compression measurements in order to understand the relationships between structural parameters of the network, its mechanical properties and protein absorption in vitro. Elastic moduli were found to vary from 1 to 17 kPa depending on the composition, while the Poisson's ratio (approximately 0.18) and deformation at break (approximately 300%) showed no dependence on this parameter. Further calculations yielded the crosslinking concentration, the average molecular weight between crosslinks (M(C)) and the mesh size. The results show that reactions between PEG and protein create polymeric chains comprising molecules of PEG and protein fragments between crosslinks. M(C) is three times higher than that expected for a "theoretical network." On the basis of this data, we propose a model for the 3D network of the hydrogel, which is found to be useful for understanding drug release properties and biomedical potential of the studied material.

No abstract