We report a direct optical super-resolution imaging approach with 25 nm (∼ λ/17) lateral resolution under 408 nm wavelength illumination by combining fused silica and polystyrene microspheres with a conventional scanning laser confocal microscope (SLCM). The microsphere deposited on the target surface generates a nanoscale central lobe illuminating a sub-diffraction-limited cross-section located on the target surface. The SLCM confocal pinhole isolates the reflected light from the near-field subdiffractive cross-section and suppresses the noises from the side lobe and the far-field paraxial focal point. The structural detail of the subdiffractive cross-section is therefore captured, and the 2D target surface near the bottom of microspheres can be imaged by intensity-based point scanning.
Volatile organic compounds (VOCs), which originate from painting, oil refining and vehicle exhaust emissions, are hazardous gases that have significant effects on air quality and human health. The detection of VOCs is of special importance to environmental safety. Among the various detection methods, chemoresistive semiconductor metal oxide gas sensors are considered to be the most promising technique due to their easy production, low cost and good portability. Sensitivity is an important parameter of gas sensors and is greatly affected by the microstructure, defects, catalyst, heterojunction and humidity. By adjusting the aforementioned factors, the sensitivity of gas sensors can be improved further. In this review, attention will be focused on how to improve the sensitivity of chemoresistive gas sensors towards certain common VOCs with respect to the five factors mentioned above.
Chemical reactions are the most important phenomena in chemistry. However, chemical reactions at buried solid/solid interfaces are very difficult to study in situ. In this research, the chemical reaction between two solid polymer materials, a nylon film and a maleic anhydride (MAH) grafted poly(ethylene-octene) (MAHgEO) sample, was directly analyzed at the buried nylon/MAHgEO interface at the molecular level in real time and in situ, using surface and interface sensitive sum-frequency generation (SFG) vibrational spectroscopy. Disappearance of nylon signals indicated a chemical reaction between amine and hydrolyzed amide groups of nylon and MAH groups on the MAHgEO at the buried interface. The appearance of SFG signals from reaction products was also observed at the buried nylon/MAHgEO interface. The mechanism of the observed interfacial reaction was further analyzed. Temperature-dependent SFG experiments were performed to measure the activation energy of the interfacial reaction, enabling a comparison with that reported for the bulk materials. The interfacial chemical reaction between nylon and MAHgEO greatly improved the adhesion of these dissimilar materials. The detailed analysis of a chemical reaction between two polymers at the polymer/polymer buried interface underscores the utility of SFG as a powerful analytical tool to build understanding of buried interfaces and to accelerate the design of interfacial structures with desired properties.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.