We report on a monolithic dual-mode semiconductor laser operating in the 1550-nm range as a compact optical beat source for tunable continuous-wave (CW) terahertz (THz) generation. It consists of two distributed feedback (DFB) laser sections and one phase section between them. Each wavelength of the two modes can be independently tuned by adjusting currents in micro-heaters which are fabricated on the top of the each DFB section. The continuous tuning of the CW THz emission from Fe(+)-implanted InGaAs photomixers is successfully demonstrated using our dual-mode laser as the excitation source. The CW THz frequency is continuously tuned from 0.17 to 0.49 THz.

We propose a widely tunable dual-wavelength Erbium-doped fiber laser that uses two micro-heater-integrated Fabry-Perot laser diodes (FP-LDs) and two fiber Bragg gratings (FBGs) for tunable continuous-wave (CW) terahertz (THz) radiation. Each wavelength can be independently tuned by using an FP-LD and an FBG. The wavelength fine tuning is achieved by simultaneously applying current to the micro-heater on the FP-LD and strain to the FBG. The side-mode suppression ratio is more than 35 dB for both wavelengths. The wavelength spacing of the dual wavelength can be continuously tuned from 3.2 nm to 9.6 nm. Continuous frequency tuning of the CW THz radiation is also successfully achieved using an InGaAs-based photomixer with our dual-wavelength fiber laser as the optical beat source. The emitted CW THz radiation is continuously tuned from 0.3 to 0.8 THz.

We demonstrate a tunable continuous-wave (CW) terahertz (THz) homodyne system with a novel detuned dual-mode laser diode (DML) and low-temperature-grown (LTG) InGaAs photomixers. The optical beat source with the detuned DML showed a beat frequency tuning range of 0.26 to over 1.07 THz. Log-spiral antenna integrated LTG InGaAs photomixers are used as THz wave generators and detectors. The CW THz radiation frequency was continuously tuned to over 1 THz. Our results clearly show the feasibility of a compact and fast scanning CW THz spectrometer consisting of a fiber-coupled detuned DML and photomixers operating in the 1.55-μm range.

We present a ten-channel distributed feedback laser diode array (DFB-LDA) developed for the transmission of 100-Gb/s (10 × 10 Gb/s) signals separated by an 8 nm wavelength grid at a center wavelength of 1.55 μm. For the fabrication of this type of laser array, a selective area growth (SAG) technique, electron-beam lithography, and a reverse-mesa ridge waveguide LD processing technique were adopted to offer a tailored gain spectrum to each channel, providing both accurate lasing-wavelength control and excellent single-mode yield over all channels, and reducing the fabrication cost and electrical and thermal resistances. To evaluate the operational performance of the fabricated chip systematically, we also developed a sub-assembly module containing a ten-channel λ/4-shifted DFB-LDA, ten matching resistors, flexible printed circuit board (FPCB) wiring, and a thermistor on a metal optical bench. The static and dynamic properties of all channels of the fabricated array are examined in this paper. The developed sub-assembly module shows a side-mode suppression ratio (SMSR) of > 50 dB, a modulation bandwidth of > 10 GHz, and a clear eye-opening before and after a 2-km transmission with dynamic extinction ratio of > 5 dB.

The structural and optical properties of self-assembled InAs quantum dots (QDs) with various InGaAs structures were investigated by transmission electron microscopy (TEM) and photoluminescence (PL). The emission peak position of InAs QDs covered by a 6 nm In0.15Ga0.85As layer was 1.26 μm with PL linewidth of 31 meV, which is narrower than that of QDs in a GaAs matrix. By inserting a 1 nm In0.15Ga0.85As layer below the InAs QD layer with a 6 nm In0.15Ga0.85As overgrowth layer, the emission peak position was redshifted with larger energy-level spacing between the ground states and the first excited states compared to that of QDs with an In0.15Ga0.85As overgrowth layer only. By covering the InAs QDs on a 1 nm In0.15Ga0.85As layer with an 8 nm InxGa1−xAs layer having graded In composition, the emission peak position was 1.32 μm with relatively larger energy-level spacing and narrower PL linewidth compared to QDs covered by an In0.15Ga0.85As layer. The longer emission wavelength with relatively larger energy-level spacing was largely related to the change in the QD shape and size, especially the aspect ratio (height/width), which was confirmed by cross-sectional TEM images.