Optical wireless communication (OWC) using the ultra-broad spectrum of the visible-to-ultraviolet (UV) wavelength region remains a vital field of research for mitigating the saturated bandwidth of radio-frequency (RF) communication. However, the lack of an efficient UV photodetection methodology hinders the development of UV-based communication. The key technological impediment is related to the low UV-photon absorption in existing silicon photodetectors, which offer low-cost and mature platforms. To address this technology gap, we report a hybrid Si-based photodetection scheme by incorporating CsPbBr3 perovskite nanocrystals (NCs) with a high photoluminescence quantum yield (PLQY) and a fast photoluminescence (PL) decay time as a UV-to-visible colour-converting layer for high-speed solar-blind UV communication. The facile formation of drop-cast CsPbBr3 perovskite NCs leads to a high PLQY of up to ~73% and strong absorption in the UV region. With the addition of the NC layer, a nearly threefold improvement in the responsivity and an increase of ~25% in the external quantum efficiency (EQE) of the solar-blind region compared to a commercial silicon-based photodetector were observed. Moreover, time-resolved photoluminescence measurements demonstrated a decay time of 4.5 ns under a 372-nm UV excitation source, thus elucidating the potential of this layer as a fast colour-converting layer. A high data rate of up to 34 Mbps in solar-blind communication was achieved using the hybrid CsPbBr3–silicon photodetection scheme in conjunction with a 278-nm UVC light-emitting diode (LED). These findings demonstrate the feasibility of an integrated high-speed photoreceiver design of a composition-tuneable perovskite-based phosphor and a low-cost silicon-based photodetector for UV communication.

We demonstrated a high-power (474 mW) blue superluminescent diode (SLD) on c-plane GaN-substrate for speckle-free solid-state lighting (SSL), and high-speed visible light communication (VLC) link. The device, emitting at 442 nm, showed a large spectral bandwidth of 6.5 nm at an optical power of 105 mW. By integrating a YAG-phosphor-plate to the SLD, a CRI of 85.1 and CCT of 3392 K were measured, thus suitable for solid-state lighting. The SLD shows a relatively large 3-dB modulation bandwidth of >400 MHz, while a record high data rate of 1.45 Gigabit-per-second (Gbps) link has been achieved below forward-error correction (FEC) limit under non-return-to-zero on-off keying (NRZ-OOK) modulation scheme. Our results suggest that SLD is a promising alternative for simultaneous speckle-free white lighting and Gbps data communication dual functionalities.

Underwater wireless optical communication (UWOC) has attracted increasing interest in various underwater activities because of its order-of-magnitude higher bandwidth compared to acoustic and radio-frequency technologies. Testbeds and pre-aligned UWOC links were constructed for physical layer evaluation, which verified that UWOC systems can operate at tens of gigabits per second or close to a hundred meters of distance. This holds promise for realizing a globally connected Internet of Underwater Things (IoUT). However, due to the fundamental complexity of the ocean water environment, there are considerable practical challenges in establishing reliable UWOC links. Thus, in addition to providing an exhaustive overview of recent advances in UWOC, this paper addresses various underwater challenges and offers insights into the solutions for these challenges. In particular, oceanic turbulence, which induces scintillation and misalignment in underwater links, is one key factor in degrading UWOC performance. Novel solutions are proposed to ease the requirements on pointing, acquisition, and tracking (PAT) for establishing robustness in UWOC links. The solutions include light-scattering-based non-line-of-sight (NLOS) communication modality as well as PAT-relieving scintillating-fiber-based photoreceiver and large-photovoltaic cells as the optical signal detectors. Naturally, the dual-function photovoltaic-photodetector device readily offers a means of energy harvesting for powering up future IoUT sensors.

Semiconductor quantum well structures have been critical to the development of modern photonics and solid-state optoelectronics. Quantum level tunable structures have introduced new transformative device applications and afforded a myriad of groundbreaking studies of fundamental quantum phenomena. However, noncolloidal, III−V compound quantum well structures are limited to traditional semiconductor materials fabricated by stringent epitaxial growth processes. This report introduces artificial multiple quantum wells (MQWs) built from CsPbBr 3 perovskite materials using commonly available thermal evaporator systems. These perovskite-based MQWs are spatially aligned on a large-area substrate with multiple stacking and systematic control over well/barrier thicknesses, resulting in tunable optical properties and a carrier confinement effect. The fabricated CsPbBr 3 artificial MQWs can be designed to display a variety of photoluminescence (PL) characteristics, such as a PL peak shift commensurate with the well/barrier thickness, multiwavelength emissions from asymmetric quantum wells, the quantum tunneling effect, and long-lived hot-carrier states. These new artificial MQWs pave the way toward widely available semiconductor heterostructures for light-conversion applications that are not restricted by periodicity or a narrow set of dimensions.

Underwater wireless optical communication (UWOC) is a wireless communication technology that uses visible light to transmit data in underwater environment. Compared to radio-frequency (RF) and acoustic underwater techniques, UWOC has many advantages including large information bandwidth, unlicensed spectrum and low power requirements. This review paper provides an overview of the latest UWOC research. Additionally, we present a detailed description of transmitter and receiver technologies which are key components of UWOC systems. Moreover, studies investigating underwater optical channel models for both simple attenuation and the impact of turbulence including air bubbles and inhomogeneous salinity and temperature are also described. Future research challenges are identified and outlined.