No abstract

Fatty acid-based polyurethane films were prepared for use as potential wound dressing material. The polymerization reaction was carried out with or without catalyst. Polymer films were prepared by casting-evaporation technique with or without crosslink-catalyst. The film prepared from uncatalyzed reaction product with crosslink-catalyst gave slightly higher crosslink density. The mechanical tests showed that, the increase in the tensile strength and decrease in the elongation at break is due to the increase in the degree of crosslinking. All films were flexible, and resisted to acid solution. The films prepared without crosslink-catalyst were more hydrophilic, absorbed more water. The highest permeability values were generally obtained for the films prepared without crosslink catalyst. Both the direct contact method and the MMT test were applied for determination of cytotoxicity of polymer films and the polyurethane film prepared from uncatalyzed reaction product without crosslink-catalyst showed better biocompatibility property, closest to the commercial product, Opsite Ò .

ABSTRACT:As an alternative to petroleum-based polyol, hydroxyl containing material was prepared from linseed oil for polyurethane synthesis. Hexamethylene di-isocyanate (HMDI) and/or 4, 4 0 -methylene diphenyl di-isocyanate (MDI) were used as isocyanate source. The polymerization reaction was carried out without catalyst. Polymer films were prepared by casting-evaporation technique. The MDI/ HMDI-based polyurethane and its films had higher T g and better thermal property than that of the HMDI-based one because of the existence of benzene ring in the polymer chain. Static water contact angle was determined to be 74 and 77.5for HMDI and MDI/HMDI-based films, respectively. Water adsorption was found to be around 2.6-3.6% for both films. In vitro degradation of polyurethanes in phosphate buffered saline at 37 C was investigated by gravimetric method. Fourier transform infrared spectroscopy and scanning electron microscopy were used for confirmation of degradation on the polymer surface. The degradation rate of the HMDI-based polyurethane film was found higher than that of the MDI/HMDI-based film. Both the direct contact method and the MMT test were applied for determination of cytotoxicity of polymer films, and the polyurethane films investigated here was not cytotoxic. Silver-containing films were prepared using Biocera A V R as filler and were screened for their antibacterial performance against Escherichia coli, Pseudomonas aeruginosa, Staphylococcus aureus, and/or Bacillus subtilis. The films prepared with and without Biocera A V R exhibited antibacterial activity.

Polyurethane films based on renewable sources were prepared as an alternative to petroleum‐based polyurethane. The effects of the structure and ratio of diisocyanate components on polymer properties were investigated. Hexamethylene diisocyanate (HMDI) and diphenylmethylene diisocyanate (MDI) were chosen as the diisocyanate components in polymer synthesis. Membranes were prepared by casting‐evaporation technique and characterized for their gas permeability, film and mechanical properties. The oil‐based membranes were found to be suitable for wound dressing applications.

No abstract