Abstract. Nowadays high temperatures resistant materials are needed to resist to high temperature applications (up to 1000°C), such as automotive exhaust gas manifolds. Some developed stainless steel grades, including ferritic grades or austenitic refractory grades, can be used in this temperature range and both in continuous or cyclic thermal conditions. In order to predict the thermomechanical fatigue damage of stainless steel parts submitted to cyclic thermal loading and constrained bonding conditions, the elastoviscoplastic model by Chaboche is determined for a wide range of temperatures, of strain amplitudes and strain rate levels thanks to isothermal traction-compression tests. The validation procedure is performed afterward by comparison with stabilized behavior under non isothermal conditions on a dedicated thermal fatigue test performed on V-shape specimens. Results of simulation show very good fitting with the experimental curves which would lead to a more accurate fatigue life prediction. A damage model was derived from Taira's thermal low-cycle fatigue model to include dwell-time period at high temperature and creep-oxidation effect. In this paper the example of K44X, a dedicated grade for high temperatures applications, is presented.

No abstract

Employing friction reduction coatings is one of the most effective methods to palliate the fretting damage. However, facing numerous available coatings, how to compare them and select the optimum one for a specific application is still a challenging task. In this paper, based on the investigation of the fretting behaviors of several bonded solid lubricant coatings, an energy approach in terms of “initial maximal dissipated energy density” was suggested to compare the tribological response of coatings. According to test results, the lifetime of each coating under different test parameters can be fitted by one master curve. The definition of this master curve for a given coating may be used for the prediction of the coating lifetime only by knowing the initial energy dissipated in the contact. The comparison of different master curves for different coatings can be employed to help the coating selection.

Abstract. In the same context of thermo-mechanical fatigue and high temperature applications of stainless steel, high-frequency vibration fatigue at high temperatures should be considered, in particular for automotive exhaust gas applications. In fact one of the most frequent incidents that can happen on exhaust components is an accumulation of low-cycle thermal fatigue and high-cycle fatigue. The prediction of the lifetime of a structure under such complex thermal and mechanical loading is therefore a constant challenge at high temperature due to the coupling of metallurgical, oxidation or creep effects. In order to better understand in a first approach, the high cycle fatigue of stainless steels at high temperatures, tractioncompression tests were performed on flat specimens at 25Hz, under air and in isothermal conditions from ambient temperature to 850°C. Two different stress ratios, R=-1 and 0.1, are characterized with the objective to assess a multiaxial model for high temperature. Different criteria are used to predict the ruin of a structure under high-cycle fatigue but in general for ambient-around temperatures. In particular, multiaxial and stress-based DangVan criterion is today widely used to evaluate the risk of fatigue cracks initiation and it has been implemented recently in our fatigue life processor Xhaust_Life®. Therefore the Dang Van criterion was identified from the isothermal high cycle fatigue using the 2 stress ratio and its validity is discussed especially for temperatures higher than 500°C where strain rate and creep effects have increasing influence. Results are presented for two ferritic stainless steel grades used in high temperature exhaust applications: K41X (AISI 441, EN 1.4509) and K44X (AISI 444Nb, EN 1.4521).