No abstract

No abstract

No abstract

Stable TiO 2 -H 2 O nanofluids are prepared and their stabilities are studied. An experimental set for studying the heat transfer and flow characteristics of nanofluids is established. Heat transfer and flow characteristics of TiO 2 -H 2 O nanofluids in a circular tube with rotating and static built-in twisted tapes are experimentally investigated and compared. An innovative performance evaluation plot of exergy efficiency is developed and the exergy efficiency of tube with rotating and static built-in twisted tapes filled with nanofluids is analyzed in this paper. The results indicate that the combination of rotating built-in twisted tape and TiO 2 -H 2 Onanofluids shows an excellent enhancement in heat transfer, which can increase the heat transfer by 101.6% compared with that of in a circular tube. The effects of nanoparticle mass fractions (ω= 0.1%, 0.3% and 0.5%) and Reynolds numbers (Re=600-7000) on the heat transfer and flow characteristics of TiO 2 -H 2 O nanofluids are discussed. It is found that there is a critical Reynolds number (Re=4500) for the maximum value of relative heat transfer enhancement ratio. The comprehensive performance of the experimental system is analyzed. It can be found that the comprehensive performance index of the experimental system firstly increases and then reduces with Reynolds number, and it can reach 1.519 at best. However, for the 2 performance evaluation of exergy efficiency, the coupling of rotating twisted tape and nanofluids deteriorates the exergy efficiency. Also, it can be found that the exergy efficiency of the circular tube with twisted tape is greater than that of circular tube under the same pumping power and pressure drop, but it shows deterioration under the same mass flow rate.

Thermal performance and pressure drop of TiO 2 -H 2 O nanofluids in double-tube heat exchangers are investigated. The influence of the thermal fluid (water) volume flow rates (q v =1-5L/min), nanoparticle mass frictions (ω=0.0%, 0.1%, 0.3% and 0.5%), nanofluids locations (shell-side and tube-side), Reynolds numbers of nanofluids (Re=3000-12000), and the structures of inner tubes (smooth tube and corrugated tube) is analyzed. Results indicate that nanofluids (ω=0.1%, 0.3% and 0.5%) can improve the heat transfer rate by 10.8%, 13.4% and 14.8% at best compared with deionized water respectively, and the number of transfer units (NTU) and effectiveness are all improved. The pressure drop can be increased by 51.9% (tube-side) and 40.7% (shell-side) at best under the condition of using both nanofluids and corrugated inner tube. When the nanofluids flow in the shell-side of the corrugated double-tube heat exchanger, the comprehensive performance of nanofluids-side is better than that of the smooth double-tube heat exchanger.