No abstract

We report the direct observation of solidlike ordering at room temperature of thin films of [Bmim][NTf2] ionic liquid on mica, amorphous silica, and oxidized Si(110). A statistical quantitative analysis of atomic force microscopy topographies shows that on these surfaces [Bmim][NTf2] forms layered structures, characterized by a perpendicular structural periodicity of approximately 0.6 nm. Remarkably, even the highest structures, up to 50 nm high, behave solidlike against the AFM probe. Conversely, on highly oriented pyrolitic graphite the ionic liquid forms nanometer-sized, liquidlike domains. The results of this study are directly relevant for those applications where ILs are employed in form of thin films supported on solid surfaces, such as in microelectromechanical or microelectronic devices. More generally, they suggest that at the liquid/solid interface the structural properties of ILs can be far more complex than those depicted so far, and prompt new fundamental investigations of the forces that drive supported ILs through a liquidlike-to-solidlike transition.

Nanostructured carbon films produced by supersonic cluster beam deposition have been studied by in situ Raman spectroscopy. Raman spectra show the formation of a sp2 solid with a very large fraction of sp-coordinated carbyne species with a long-term stability under ultrahigh vacuum. Distinct Raman contributions from polyyne and cumulene species have been observed, as well as different stabilities under gas exposure. Our experiments confirm theoretical predictions and demonstrate the possibility of producing a carbyne-rich pure carbon solid. The stability of the sp2-sp network has important implications for astrophysics and for the production of novel carbon-based systems.

Bacterial infection of implants and prosthetic devices is one of the most common causes of implant failure. The nanostructured surface of biocompatible materials strongly influences the adhesion and proliferation of mammalian cells on solid substrates. The observation of this phenomenon has led to an increased effort to develop new strategies to prevent bacterial adhesion and biofilm formation, primarily through nanoengineering the topology of the materials used in implantable devices. While several studies have demonstrated the influence of nanoscale surface morphology on prokaryotic cell attachment, none have provided a quantitative understanding of this phenomenon. Using supersonic cluster beam deposition, we produced nanostructured titania thin films with controlled and reproducible nanoscale morphology respectively. We characterized the surface morphology; composition and wettability by means of atomic force microscopy, X-ray photoemission spectroscopy and contact angle measurements. We studied how protein adsorption is influenced by the physico-chemical surface parameters. Lastly, we characterized Escherichia coli and Staphylococcus aureus adhesion on nanostructured titania surfaces. Our results show that the increase in surface pore aspect ratio and volume, related to the increase of surface roughness, improves protein adsorption, which in turn downplays bacterial adhesion and biofilm formation. As roughness increases up to about 20 nm, bacterial adhesion and biofilm formation are enhanced; the further increase of roughness causes a significant decrease of bacterial adhesion and inhibits biofilm formation. We interpret the observed trend in bacterial adhesion as the combined effect of passivation and flattening effects induced by morphology-dependent protein adsorption. Our findings demonstrate that bacterial adhesion and biofilm formation on nanostructured titanium oxide surfaces are significantly influenced by nanoscale morphological features. The quantitative information, provided by this study about the relation between surface nanoscale morphology and bacterial adhesion points towards the rational design of implant surfaces that control or inhibit bacterial adhesion and biofilm formation.