is an open access repository that collects the work of Arts et Métiers ParisTech researchers and makes it freely available over the web where possible. A B S T R A C TThis paper describes a hybrid additive manufacturing process -3D Laser Shock Peening (3D LSP), based on the integration of Laser Shock Peening (LSP) with selective laser melting (SLM). The well-known tensile residual stresses (TRS) in the as -built (AB) state of SLM parts in the subsurface region have a detrimental effect on their fatigue life. LSP is a relatively expensive surface post treatment method, known to generate deep CRS into the subsurface of the part, and used for high end applications (e.g. aerospace, nuclear) where fatigue life is crucial. The novel proposed 3D LSP process takes advantage of the possibility to repeatedly interrupt the part manufacturing, with cycles of a few SLM layers. This approach leads to higher and deeper CRS in the subsurface of the produced part, with expected improved fatigue properties. In this paper, 316L stainless steel samples were 3D LSP processed using a decoupled approach, i.e. by moving back and forth the baseplate from an SLM machine to an LSP station. A clear and significant increase in the magnitude and depth of CRS was observed, for all investigated process parameters, when compared to the AB SLM parts, or those traditionally LSP (surface) treated.

is an open access repository that collects the work of Arts et Métiers ParisTech researchers and makes it freely available over the web where possible. a b s t r a c tThe direct metal deposition (DMD) with laser is a free-form metal deposition process for manufacturing dense pieces, which allows generating a prototype or small series of near net-shape structures. One of the most critical issues is that produced pieces have a deleterious surface finish which systematically requires post machining steps. This problem has never been fully addressed before. The present work describes investigations on the DMD process, using an Yb-YAG disk laser, and a widely used titanium alloy (Ti-6Al-4V) to understand the influence of the main process parameters on the surface finish quality. The focus of our work was: (1) to understand the physical mechanisms responsible for deleterious surface finishes, (2) to propose different experimental solutions for improving surface finish.In order to understand the physical mechanisms responsible for deleterious surface finishes, we have carried out: (1) a precise characterization of the laser beam and the powder stream; (2) a large number of multi-layered walls using different process parameters (P(W), V(m/min), D m (g/min), Gaussian or uniform beam distribution); (3) a real time fast camera analysis of melt pool dynamics and melt-pool -powder stream coupling; (4) a characterization of wall morphologies versus process parameters using 2D and 3D profilometry.The results confirm that surface degradation depends on two distinct aspects: the sticking of nonmelted or partially melted particles on the free surfaces, and the formation of menisci with more or less pronounced curvature radii. Among other aspects, a reduction of layer thickness and an increase of melt-pool volumes to favor re-melting processes are shown to have a beneficial effect on roughness parameters. Last, a simple analytical model was proposed to correlate melt-pool geometries to resulting surface finishes.